Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By CruisinMT
Got my 67’ running again today. It’s been sitting about 8 years in my shed. Sucker fired right up. I decided to go with JT Outfitters full disc brake conversion instead of an axle swap and also an HEI distributor from there as well. I’m also looking a possible a new 1/2 tub or replacement rear floor and rear fenders. Any suggestions on which company is the best bang for the $$$? Here’s a vid of it running.
By cj's mopar
So here is why you can't plunk down 1800 for anew posi and street strip drive a 500 HP car with 8.75 rear axle and a 4speed. This factory Yukon gear 8.75 had 150 street miles 25 street hits and one drag strip burn out and this happens at the line. PSA don't buy clutch type Yukon gear for any thing that is more then stock . And even then I would not buy it . This is not to slam any one I just want to warn our Mopar community this stuff is not safe for spirited muscle cars at all! Save your... Read more
By Mudrig150
Ever since my 85 exploded the amp meter and filled the cluster with smoke stains, I've noticed that my dash lights were extra dim. I decided to clean it up and repaint the inside gloss white to see...
By chap79
To get this started off right... Make sure to post a picture and the ad for prosperity sake. Might be too good to be true 1984 Toyota Land Cruiser FJ43 1984 Toyota Land Cruiser FJ43 - $10000 -5 speed transmission H55f Five-speed & reverse shift smoothly through all gears -Factory Power steering -Front disc brakes -Aftermarket Ac -Strong 2f Engine -Custom front bumper -Roll bar -Warn winch 8,000Lb -Front bucket seats -16'' Toyota alloy wheels -Led... Read more
By Photomania
Curious as to how many on here have two Corvettes? Or do you have a Corvette and another sports car? Or do you have a Corvette and a muscle car, such as a Mustang GT, Charger or Challenger?
By 72 BLUE 400
Bought this filter off eBay not even close to fitting,seller states exact fit,hopefully this saves someone else from being disappointed
By Phillbo
Looking to add some capacity to my system by installing a bigger battery in the 300aH range. Price and quality appear to be all over the place. Any suggestions on a quality built brand thar will...
By alyels
Hey everyone, I’m creating a separate thread because I believe my experience with my brand-new 992.2 GT3 deserves more visibility, and I’d genuinely appreciate advice from other Porsche owners who...
By pacofortacos
This is my next mod after driving across the midwest! https://shop.advanceautoparts.com/p/carquest-dimmer-switch-52c1003/12507551-P The steering column high beam switch location just gets old after a few hours of on and off hahaha. Foot switch would be so much easier to use in those situations.
By 65Cudafix
So, I've got a 1983 D150 (base model 4x2 may even be a D100...) with a slant6. Just wanted the engine to see how the Aussies Tubo charge the MFers.. Then reason crept in: Truck body isn't bad, and nothing to put the Slant6 into anyway... So, why not just put a hyper-pak on it and paint it to look like a school bus, and let my kid (he teaches school) drive it... So Question is, what is the value in doing any more that simply installing the manifold, headers and oil cover. Follow on... Read more
By Gordon888
So... LONG STORY SHORT. I did a complete refresh of all my control arms front and rear because the damn car was clunking with my KWv3s that were also blown. The collection of parts went well, got...
By The Proton
After owning my 80 series for about 10 years it developed a crack in the upper tailgate. It looks like a fatigue crack. At the time I figured it was due to me standing on it to open the RTT. I ended up finding a used tailgate and replacing it. After the new one went on I also added a new rear bumper I could stand on, and stopped standing on the tailgate. A few years later the same crack appears…. I just replaced the tailgate again. I don’t want to buy a third one. Any ideas what could... Read more
By C17
In my 1976 Corvette's tilt/telescopic steering column, the telescopic wedge (the telescopic wedge set inside the upper steering column shaft) has slight play within the upper steering column yoke...
By voodoo340
N.O.S. MP 500 BB Crate Motor MP P/N P4876691 Purchased new in 2000 for a '68 RoadRunner project that never happened (have original receipt from Summit Racing). Stored properly in dry garage since new. Includes original engine stand and lift plate (blue crate disposed of long ago due to large size taking up too much space). I have added all front accesories and ignition, so engine is now fully dressed and ready to run (I would re-lube the cam before first fire though). See attached current... Read more
By gmd25m
1992 e150, 4.9 300, E40D tranny, 280k miles Flying down the highway at around 75-80 mph and my engine cuts off. Luckily with momentum and position on the road I was able to coast to the right...
By dudemancool1904
Not a huge deal but for someone OCD like me it’s enough to push me over the hill to buy a tune. According to the EO it covers all 3ur vehicles 2008-2021 LC/LX/Sequoia/Tundra https://m.facebook.com/story.php?story_fbid=pfbid0LNDeUSKCkoGSunjaxTedgr9fJhfeeVZXjgkZqZSAmMgw4Dw8j6LcMpSNkLDYXbbKl&id=100043734221714&mibextid=wwXIfr
By Data Plate
I have a 69 Roadrunner a Guy by me has he has a new quarter panel that he didnt use he would sell me. He said its made by AMD but has no box or paperwork my question is did AMD stamp there parts anywhere where I could look to verify ?
By AlfaBetaSoup
Has anyone replaced the battery of their GV70 with something other than the very expensive and difficult-to-acquire O.E.M. factory battery? Will a H8 AGM fit? I have been led to believe the issue of finding a non-O.E.M. battery relates to the reverse polarity of the O.E.M. battery. True?
By Chamba
For those of you who have been on Mud a while, you may know me. But for those who've joined in the last 6 or 7 years, I'm really no one. I've been a Cruiser guy since I was nearly 3 when my folks bought a brand new '72 FJ40 at Lyons Toyota in Boulder. My cousin still has that 40 in the family. I've had numerous Cruisers all my driving life: a '76 FJ40, an '83 'FJ40 with factory power steering and air, an '84 HJ47 troopy and an '84 FJ40 LX being the main characters with numerous others... Read more
By Lowe516
Lights worked fine prior. I disconnected the light leveling arms in the wheel wells before installing the lift. But now , no illumination on the side I am turning towards. Any ideas?
By Oldmopartech
I am in need of a headlamp switch wiring diag. 98 Ram 1500 With head lights on I have no gauge lights until I use the dome lamp
By jejb
Thinking hard about deleting my '22 2500. Love the truck, hate the frequent regens. I had a long email string with "The Diesel Dudes" yesterday figuring out exactly what I need. They were VERY helpful and informative. Even had me pull the E/C number. But then I did some research and found a fair amount of folks that had bad experiences with them. Granted, the negative stuff was mostly from a couple of years ago, but it made me look around. Here is who I see making delete kits so far: GWN... Read more
By folivier
Just completed a 1400 mile drive. I was driving my motorhome pulling a trailer and my wife followed me in our '06 GX470. Average speed was 60mph and she averaged 22 mpg. No problems at all on the trip. These things are tanks!
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
