We’re 14” Magnum 500s ever offered OEM in 1966
By AR67GTX
They seem almost universal on 66/67 models anymore but not sure if ever mounted by Chrysler as early as 1966.
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By AR67GTX
They seem almost universal on 66/67 models anymore but not sure if ever mounted by Chrysler as early as 1966.
By hessam69
What do folks do about the power steering when there is no AC to turn the belt? Is there a power steering only mounting bracket that doesn’t use AC? If so does anyone have pictures of the setup?
By Trail Teq
Gday Mudders! The Trail Teq family is going away on holidays for a few weeks this coming Saturday, so we're running a 15% Off Storewide Sale during this time + a special discount opportunity for IH8MUD members. We manufacture a variety of products, but our specialty is Plug-and-Play Electrical Products, such as our Keyless Entry Systems, which we now offer for 12 Models of Classic Toyota 4WD's, soon to be 15, with the 1st Gen Tundra, FJ Cruiser and 60 Series Land Cruiser kits ready for... Read more
By Hyper_pak
Installed just to hang the door. Never been out of the garage. $60 Shipped in the US. OER Brand Free pickup near DFW Texas I take PP to Friends or Cash Questions?
By 98pepsiblue2GS
The GS4 will skip 2nd gear and have a flashing M when warmed up. The car is completely fine until about 20 minutes into the drive, where it will then start to skip 2nd gear and no manual mode. I...
By bbbb
Reilly Motorsports has terrible customer service! Bill from Reilly Motorsports would not replace a set of axles that were sent to me and were too long. After spending 10's of thousands of dollars on their parts Bill told me his vendor had screwed up and sent the wrong axles and that I should just cut a 1/4" off each axle with a cutting wheel! Not going to happen! After numerous emails to Bill he finally responded telling me because the order was six years ago he refused to just send me... Read more
By Nick@GotExhaust
Eibach is offered here at Got Exhaust! Eibach springs have supported innumerable race and championship winners over the last two decades. In series as different as Formula 1 and NASCAR, the winning factor is often chassis setup and tuning. When everybody has comparable power, the guy who wins is the guy who can put that power to the ground-and maintain his momentum through the corners. The list of Eibach partners reads like "Who's Who" in Motor Sports: AMG, Audi, BMW... Read more
By Deweywinger&howe
Have a grille from a 1974 duster/valiant The headlight drs are good also I'm at $140 could bring to St. louis Tim in iowa
By brandiclay
I’ve searched the forum, unsuccessfully, and searched the web, unsuccessfully, to find replacement spring perches or templates to have them made. I can’t be the only one who’s experienced this. I’m currently having the frame repaired but clearly these will need attention. Can anyone direct me to a discussion that’s already been had or tell me what they have done? And yes, I know this one’s ugly, so go easy on me.
By galarianash
Hello Everyone!!! I have a 2017 Honda Civic Hatchback (CVT) Mod List so far: Greddy DD exhaust non resonated PRL cobra CAI ETL cooler (waiting for my sirimoto flex fuel kit, on backorder with no estimated ship date) Removed weight, took out back seats, carpeting back there, and spare tire I recently got the CVT trans cooler by ETL performance. Link: https://etlperformanceproducts.com/products/transmission-oil-cooler-kit-honda-civic-cvt First things first, this is a BITCH to... Review of the ETL CVT Cooler
By DentsideFan
Hey, my 1989 f-150 5.0 M5OD-R2 4x4 is having idle issues again. Alright here's the issue. When I'm driving it acts just fine zero issues with power and getting up to speed and all of that, But...
By BSP
Hello All, I am experiencing some valve tick on my number one exhaust valve and cannot understand why. The valves are correctly set for lash set at operating temp. When the engine is cold, there is no loud valve noise. However, as the engine is warming up, starting approximately 3 to 4 minutes after cold start, the ticking on this one valve becomes noticeably louder. Once the engine reaches operating temp, the noise goes away again. Any thoughts on why this valve only makes noise when... Read more
By KDanM
Hello all. I have a 2018 Tradesman with a radio 3.0 (RA1) w/ satellite (RSD) and w/o Bluetooth. I'd like to replace it with the same thing due to a cosmetic issue with the buttons on the radio caused by the extreme heat in south Texas. I have no interest in upgrading, and no interest in going aftermarket. I'd like to just get a used radio from a salvage yard or ebay. Some of the ebay sellers as well as the salvage yard I went to as well as chatGPT say I may need to get the replacement radio... Read more
By tom999w
This was in my '71 Demon that sat in the junkyard for 25 years without a drivers door. There are lesser gauge clusters for sale on the classifieds. Is this junk? I don't have any way of testing any of it. I accidentally snapped off one pin, but that can be fixed if needed. Other than that, it appears to be in ok condition.
By Gx89
2006 gp1 part out Hey guys, parting out my gp1 since sale didn't go through. 06 gp1 clean title. 82,000 miles*(parting out now)* Mods : -both cluster $500 82,000 miles -sprintex gen 2...
By ProjectApollo52
So i have a 2013 lexus LX570, its got over 190k miles and ive owned it since it had 0 miles on it, recently the AHC pump went out so i replaced the pump, the shocks and struts, and the globes all at the same time all are oem toyota/lexus parts, ive made sure to bleed the system at all four corners AND the 5th accumulator and i can confirm there is no air left in the system, the car will go to the high position, normal and low position with no problems, HOWEVER only the front end seems to be... Read more
By veesix
2021 G80 Prestige 3.5T AWD -- When I open the skyroof, hot air comes out of the dashboard vents. The air is as hot as with the heater on full blast. The fans are not on, so the air is mostly driven in when I am driving at 50 mph or so. This is my 4th Genesis and none of the past ones had this problem. Is there a way to turn the hot air off? Does the can need repair? Anyone know what is happening?
By MTFtype
Hey guys, new to the forum. As the title suggests I'm in the market for a Manual F Type S 2016+ ideally in BRG over tan. I've also been keeping an eye on this example but it's a bit high mileage and...
By Mezeno
I recently purchased a 1993 VX HDJ81 Turbo 5spd manual. It was driving just fine until I put diesel fuel injector cleaner in it. When I am driving everything is fine until 2500rpms. At that point the engine acts starved for fuel or it feels like its missing. Press on the gas anymore and it is struggling. Things are fine in the next gear until 2500rpms. Down shifting is as problematic at 2500rpms. Power loss when downshifting on a hill when pressing on the gas too much. It is also stalling... Read more
By KaziuPL
Please help me figure out how to load European maps onto my car radio. It is a US-spec vehicle. Greetings from Poland
By Jon O'Brien
Set of four Hartmann HS5-209-GA:M wheels, 19x8.5", ET25, 5x112. I used them on a 2014 SQ5 but they are compatible with a wide range of Audi vehicles that use a 5x112 bolt pattern. No curb rash,...
By Saluqui
How to you pull off the electrical connector on the top of a 2000LC fuel pump? My fingers are sore from squeezing the tab. Is there a tool needed? Thanks!
By Deweywinger&howe
l have an 3.21 big bolt pattern 8 1/4 rear from a 73 duster I'm at $325 l can bring to st. louis blast if paid Tim in iowa Should have brakes included
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.