EFI Schrader Valve
By jortucson
90 460 I'm troubleshooting why the engine shuts down when I select the front tank. The selector switch is good. Both pumps run on startup. Now I'm trying to test the fuel pressure at the EFI rail....
Discover
News, forums and creators
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
Latest threads
Filters
All publishersCorvetteForumRennlistIH8MUDFord Truck EnthusiastsFor B Bodies OnlyFor A Bodies OnlyMBWorldClubLexusRamForumAudiWorldJaguar ForumsLucid OwnersCivicXClassicBroncosTurbobricksSVTPerformanceGenesis OwnersMazdas247RX7ClubHonda-TechNorth American MotoringInsideEVs ForumEvolutionMMy350ZFT86ClubRenntech
Transmission Help needed
By Gunner56
Afternoon all, Looking for some assistance locating shop or transmission for a 2003 Landcruiser (A750F). Seems all reman units are on national backorder and parts are near impossible to come by when executing a rebuild. Would be looking for a good unit out of a parts truck or that someone has sitting around, or maybe a Toyota specific trans shop that may have the parts to get it done. I have the truck going to a trans shop to properly diag the issue, but right now I am getting hard... Read more
PTS Green 992 GT3 RS | Full Body XPEL PPF & Ceramic Coated Wheels | TAG MOTORSPORTS
By TAGMotorsports
*Image: (https://tagmotorsports.com) Paint to Sample Porsche 992 GT3 RS, protected by TAG Motorsports.* Every now and then a car comes off the flatbed and the whole shop walks outside. This...
14x5.5 rallye wheel trim rings??
By ec_co
Apparently I accidentally bought the wrong trim rings (14x7) and I'd like to avoid doing that again. Are there specific trim rings for the 14x5.5 or will 14x6s work? Does anybody have a link to what will be correctish
Rear window tinting
By MiamiCowboy
What are your thoughts on tinting or not the rear glass over the engine compartment.
2001 XC70 weak points?
By ZVOLV
Isn't there some "ball bearing" that can get sucked into the intake on FWD cars? What else on the 2001 XC70? I have it in the garage right now. I am doing the timing belt and the blown spring/strut mount. The strut has freed itself from the rubber and I fear it is a threat of blowing thru my hood. Lemforders spring mounts going in right now. I have a Service Alarm message. Research says there is a battery that needs to be replaced in a siren module in the right tire well. What else... Read more
PTS Green 992 GT3 RS | Full Body XPEL PPF & Ceramic Coated Wheels | TAG MOTORSPORTS
By TAGMotorsports
*Image: (https://tagmotorsports.com) Paint to Sample Porsche 992 GT3 RS, protected by TAG Motorsports.* Every now and then a car comes off the flatbed and the whole shop walks outside. This...
I've been using the Duck Duck Go browser
By SteveSS
The tracking attempts it has stopped are shocking. Not going to name any website names.
Grand Sport is Home
By MiamiCowboy
Picked up in Bowling Green 10/9 and driven home to Oklahoma. Nannies dropped off the last 60 miles so step 1 is complete. Used Z Mode in Sport and the car performed marvelously. The C8 is a big step...
Rear Fender HashMarks
By deemer
Does any have pictures of a Red Mist with black rear fender hash marks? If so, would you mind posting them. Thanks in advance.
C2 Shock absorber mount bolt and nut question.
By riggsjr
I swapped out my top washer on my 66 as it had the wrong washer period correct.I am afraid to torque the mounting nut to 20 ft lbs as to crush the rubber bushing.It also looks like the new top washer...
In Stock: LEMS Titanium Intake Pipe (Blue) for 2008-2014 Lexus IS F (LEMS-L114-BL)
By ModInJapan
Hi everyone, Mod in Japan here. We wanted to share a titanium intake pipe for IS F owners that we currently have on our shelf. Image: ...
2.1 GTS 7 speed to GT4RS
By GTS2022
I have owned my 2.1 GTS 7 spd for almost 4.5 years. i love every aspect but at the same time want to experience something different. I drive it as much as I can and now have nearly 14k miles. The...
Grand Sport or Grand Sport X?
By Amerikanisch
I dont intend to track my car and I will do very little high-speed hairpin turning. I may occasionally step on the accelerator for the thrill of acceleration but I won"t do a lot of that. I am buying...
Demon Duster guys!
By Ironmike
Hi guys! If any of you have a passenger door mirror, could you check placement for me. Putting one on my Demon and some car cruise guy told me they do NOT mount the same spot on the door. Could use a measurement, if possible. It's on it's way from Classic and I sure don't want to drill holes in the wrong spot.
Leaking header with air injection ports
By 1911a1
Well my worst fear was confirmed today. Pulled the old gasket on the passenger side of the 318 in the Duster and sure enough it appears I may have the dreaded air injection ports below the exhaust port. I’ll unbolt the collector and maybe that will give me a little better access to these holes. There’s not enough room to tap these so I may end up cleaning with a tiny brush and carb cleaner and try to seal off with JB Weld smeared with a pop cycle stick
Pirelli P Zero Trofeo RS N1 Tires – New Set for Porsche 992 GT3 – $2,400 OBO
By sl951
Pirelli P Zero Trofeo RS N1 Tires – New Set for Porsche 992 GT3 – $2,400 OBO Brand-new, never-mounted set of four Pirelli P Zero Trofeo RS tires with Porsche N1 homologation. Sizes: 2 ×...
V inspection pics.
By dave1987928s4
87 S4 with 100k. Valve covers off and a bit of a mess was discovered. Lots of heat damage. I suspected my ISV was bad but instead it looks like several vac holes. I should’ve put my mity on it. ...
Can the C8 headlight clear lens cover be replaced?
By iflex2fitness
Can I just replace the lens? Would this be covered under the platinum gm extended warranty? Will I have to replace the whole headlight? Thanks
1970 Coronet Parts
By benbuilder
For some reason i cannot edit my original ad, So i will give an updated list as to what is sold/available-generally rubber behind bee wing grill alternator with 2 groove pulley- aftermarket alternator Driver side headlight shield 2998681 am radio -core, no knobs headlight rings weatherstripping under hood glove box from a 1970 wagon Radiator Fan shroud perfect 2998326 Crager 1/2-20 left hand thread lug nuts - 5 of them in original box. One was installed then removed 9007 lots of good... Read more
2005 ram 4.7 random loss of power, pulling 7° timing, no clue why. Please help
By krankmotorsports
Hello yall. I got a real problem child ive never seen before. I drive the same way to work every day. I can 100% feel the power loss. Its the difference in climbing a hill at 50mph at 25% throttle, then next time it takes 80% throttle to get up same hill barely getting to 50mph. Watching data, appears that something is ringing the knock sensors, causing ecu to pull up to 7.5° timing......which kills power and fuel milage. Had a lifter chatter at startup, replaced all lifters... Read more
WANTED:: under hood wiring brackets for starter wire and speedo cable 1969 Super Bee (SEE PHOTOS)
By FASTEDDIE1960
Looking to buy the 3 under hood wiring brackets for my 1969 Super Bee body shop lost mine, These are the 3 brackets on the lower driver side inner fender that hold the battery to starter cable and the speedometer cable/brake line... (PLEASE SEE PHOTOS) will need shipped to IOWA 51014....Thanks very much, have an awesome day.
FS (For Sale) 1967-68 Timing Chain Cover with 'A O R' Timing Tab
By TMcP
_** * * $120.00 plus $10.00 U.S. shipping * * **_ Original Big Block Timing Chain Cover for 1967-68 Corvette 427/430 & 435hp with 'A O R' timing tab. Also 1967-1968 Camaro, Chevelle. GM #3885054....
Forums & communities
110 listed, 26 connected and bringing in items.
Suggest a source
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.