Why no companies build off the corvette platform?
By C4barnrescue
Back in the C4 days lots of companies offered an aftermarket corvette. Image: Image: Image: Image: Image: Image: Image: Image:
Discover
News, forums and creators
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
Latest threads
Filters
All publishersCorvetteForumRennlistIH8MUDFord Truck EnthusiastsFor B Bodies OnlyFor A Bodies OnlyMBWorldClubLexusRamForumAudiWorldJaguar ForumsLucid OwnersCivicXTurbobricksClassicBroncosSVTPerformanceGenesis OwnersMazdas247RX7ClubHonda-TechNorth American MotoringInsideEVs ForumEvolutionMMy350ZFT86ClubRenntech
76 Fj40 Face Lift
By Chungas Revenge
I picked up a 76 TLC Fj40 about three years ago. Saw my 1st "40" up close when I was a kid. While sharing lunch with a fellow hunter I met, I commented on his "Jeep"...Well you get the picture. I got the lecture! The seed was planted and I picked the "red pill" shoulda' went with "blue". Fast forward thirty years later to North Africa, and I am driving a 10,000 pound, Up-armored Land Cruiser. Other than new tires every month or so, that machine was indestructible and despite it's... Read more
2UZ transmission thoughts.
By Tigerstripe40
I am considering putting a 2UZ drivetrain into my FJ40. The FJ40 would be stretched 10". I've been planning to get a 2UZ and A750 and associated wiring out of a Sequoia. This can be connected to the J80/J100 transfer case with a 3:1 low range gear set. But the A750 is VERY long. If I could, I'd run a TR4050, but I have not been able to find a bellhousing adapter to a 2UZ for that transmission. H55F bellhousing needs to come from Australia and I need to ship the ring gear overseas. This... Read more
Early Ford Bronco front bucket seats with brackets and center console
By bronconut1
Nice recovered front bucket seats with brackets and center console.
T-56 rebuild parts. School me !!
By blwn89gt
I decided I’d like to pull my t-56 out and I want to “freshen it up”. I don’t know much about the components inside, but I see rebuild kits with carbon fiber synchro rings and bronze fork pads. I know Tick performance sells a kit, but it’s out of stock. Does anyone have any recommendations on where I can buy a good rebuild kit with good components, and if there’s anything specific I should get while it’s torn down? I’ll throw it out there now that a magnum would be ideal, but it’s not in the... Read more
Range
By grispler
Hi, Lucid changed the batteries on my 2022 Lucid Grand Touring last year and I never get more than 270 mile range even at 100% -- they say every thing is fine --- does this sound right? I have the larger rims which they say brings it down 10% - I've been running tests not driving too fast slower acceleration and still nothing close to 300 I live in Florida so its not cold weather -- does 275 mile range sound right? I told them to keep the car until they do something Greg
Got tired of my steering wheel blocking the Glass Cockpit—so I did this
By xwave
Disclaimer: Modifying a steering wheel may affect airbag performance and compromise safety. I’m sharing my personal project, but I don’t recommend this modification. I got tired of the top of the steering wheel blocking my view of the Glass Cockpit, so I bought a used OEM steering wheel, cut off the top section, and sent it to an upholstery shop to have it refinished. Here’s the finished result! Much better visibility, and I still have my original wheel if I ever want to switch back... Read more
1966 440 coronet roller
By 44o gts dart
Hey my neighbor has a 1966 roller coronet 440, 2 dr hardtop,,I guess all new floors and new metal, with a lot of spare trim and doors and things… any interest out there? I promised him to post it … t I a
68 Coronet R/T 727 Lower shift rod with swivel
By BBrunner
Hello, I am looking for the trans rod from trans to torque shaft with swivel. Application is 68 Coronet R/T Auto column shift. The attached picture calls it a "rear rod & swivel assembly". I have no idea of length or bend location as I don't have one for a sample. Thanks.
Atypical coolant burn behavior d15b2
By crxbb45
I need some help, or ideas. On a cold start, it will run *and drive* perfectly for as long as its running. now when you shut the engine off, wait a minute, and restart it, it starts burning...
Caliper color change advice
By zginganinja
Recently got a 2026 stingray w/ z51 package that’s all blacked out including the calipers. I’d like to change them to red. What route should I go? -find a body shop to powder coat them -replace...
Wanted template for wheel well cover extensions for 993 RS sides
By samurai_k
I lost my wheel well extension covers for the 993 RS sides somewhere in my parts hoard. Do any of you have a template I could make a new set? Picture from Bill's blue RS Image: Image:
Best Cost-Effective Alternator Upgrade for a 1987 Volvo 240 – Denso vs. Bosch, Pricing, and Installation Advice
By CoolSantaCruzer
Best Cost-Effective Alternator Upgrade for a 1987 Volvo 240 – Denso vs. Bosch I'm looking for recommendations for the best cost-effective alternator upgrade for my 1987 Volvo 240DL (B230F) , which currently has the original 80A alternator. I have additional audio equipment and other electrical loads, so dependable charging is important. In particular, I'd like better charging at hot idle and low engine speeds, not simply a higher maximum amperage rating. I'm open to 100A, 115A... Read more
Im ready for a tune!!!
By Shark408
So I feel my Carrera S is slow now amd ready for the more power.She is a 2024 with Soul 200 cell cats woth 3000miles. Help me decide on a tuner. I’ve searched and found M engineering amd Softronic...
put more positive caster on side that pulls ????
By ignatz
My car pulls slightly to the right. It is up on my lift and I need to make a tweak in the alignment while I'm doing other things. Looked through my service manual notes and I see that I wrote that...
Need C5 Alignment Lockout Kit installed
By mueller54
Need a C5 alignment lockout kit installed. Looking for a shop, hopefully in Wisconsin, that is willing to do this. Willing to travel if necessary, thank you for any recommendations.
R50/R53 Help identifying this line and fuel leak in engine
By john411
O Image: I was looking for the source of the fuel leak and I found it. Apparently that hose was resting on a screw. But now when I was moving things the hose next to it broke. Anyone know what...
1990 C4 No Crank - No Security Light
By 90sChild
Hello folks, New the C4 world and I want some advice on an issue I am having. I just picked myself up a 1990 C4 6 speed that has been sitting since 2004. The car is 100% original and I picked it...
On The Hunt for a G70
By PapaMilano
Hi, folks. I'm in the hunt for a new or used '25 or newer G70 in the Nashville area. I like the looks, 3.3T reliability (comments to the contrary are welcome) and am focused on a Sport Prestige AWD. I'd appreciate any and all comments on your experiences as seasoned G70 owner with regards to engine (especially) and general car reliability, dealer experience, quirks, gotchas, etc. I'll be scouring the rest of the G70 and 3.3L posts over the next few days in order to make a decision. Thanks... Read more
DIY: Oil temperature sensor
By st4xor
Here is a DIY write up for oil temp sensor + gauge install. There are a couple more pictures I might have liked to add here, but this should give anyone who is interested a good overview, and then feel free to ask questions. This thread should be applicable to any 10th gen civic where a discrete aftermarket oil temp sensor is desired. I have a 1.5t civic si sedan, which has no oil temp/pressure data (not even estimated temp/pressure) available through the CAN system. I also do not... DIY: Oil temperature sensor
997.2 GT3 RS (3.8) – 2nd/3rd/4th notchy & grinding while driving, light clutch pedal
By Edoos
Hi all, Just picked up a 2010 997.2 GT3 RS 3.8, manual, 10,800 km, full Porsche history. Looking for input from owners who've been through something similar. Symptoms: - 2nd, 3rd and 4th are...
2008 Cayenne GTS – Intermittent Key Start / Dead Horn / Relay 433 / KESSY Faults
By jesj
*Vehicle Specs & History:* • Model: 2008 Porsche Cayenne GTS (4.8L DFI V8), 166,550 miles. • Inciting Incident: Car was jump-started from cold. It ran/drove for 90–120 minutes, then stalled. It was...
FS (For Sale) My Entire Hoard
By Masonmatt
[size=13px]$4500 all or nothing. Serious inquiries only located in Lebanon, OH 45152. Send message to exchange contact information. [/size]Pictures show all of the items. *Most* parts are from a 66...
Forums & communities
110 listed, 26 connected and bringing in items.
Suggest a source
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.