Batteries - what is a good option today?
By KC8QVO
All, I need to replace my batteries again. Looks like last time I went through this was in 2017: https://www.ford-trucks.com/forums/1516937-dead-batteries.html I wouldnt say I got 9 years...
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By KC8QVO
All, I need to replace my batteries again. Looks like last time I went through this was in 2017: https://www.ford-trucks.com/forums/1516937-dead-batteries.html I wouldnt say I got 9 years...
By rklewis1005
When I attach the Heat/Defrost cable to the heater box it won't move via the controls. I've tried routing the cable a few different ways to keep the loops big / not tight. The dash was restored by Instruments Specialties, so I'm assuming the cables are the right length. Any hints/suggestions? It moves when I unhook it, and the cable is straight. I've considered shortening the cable so it doesn't loop, but I think that would make the turn even tighter. It'd be a 50/50 shot, and I'd have to... Read more
By WiseHustlers
Wise Hustlers Technologies Pvt. Ltd. is a leading web and mobile app development agency dedicated to transforming innovative ideas into powerful digital solutions. We specialize in custom website...
By Lekhooamike
please assist in getting wheel arch trim on the passenger side
By Simplespirit
I have an 09 with OME lift, OME UCAs, OEM 18x8 +60 wheels, 3/4 spacers (taking offset to +41), and 275/70R18 tires. The 1" KDSS max relocation kit has also been installed. At this point I have very minor rubbing on the inner most part of the front fender liners (drivers side when turned right and passenger when left). Front hub to fender: 22 Current alignment spec (most recent one I have anyway) Camber L -.2 Camber R 0 Caster L +3 Camber R +3 Toe L +.14 Toe R +.14 If I add more caster, is... Read more
By RiverRatMatt
I'm want to put two of my auxiliary front lights onto my high beam circuit. The question I have been pondering, however, is where to wire them so the high beams turn them on. From what I understand, the high beam lights are used as the DRLs, just run through a resistor to lower the brightness. When the high beams are turned on, the resistor is bypassed somehow. I'm assuming I can't just wire the relay for the aux lights into the high beam fuse, because it would always be on (aside from when... Read more
By Kern Dog
I'm sure many may have already seen this but I still like it....
By 72 Pacer
wanting an early 73 J code 400 BB, complete/short block/what have you?? Cheers Andre
By Baltika
People follow reviewers and influencers because they offer something genuinely useful: access to cars most of us can’t drive back-to-back. But with a 911, there’s a problem. What they’re reviewing is...
By greenbeast
Thought I’d keep it simple and it couldn’t be more appropriate. We just got home with Bonnie and we couldn’t be happier. 1000 miles, 4 states and around 16 hours driving back home we are so excited. Have to give Jim and Bonnie a big thank you. Words don’t express how thankful we are. Bonnie told Kim she wasn’t quite ready to let it go which made it difficult for Kim and I. Wind came up taking pic of Jim and Bonnie before we left getting some dust in my eyes and I’ll be damned if it... Read more
By z32fairlady
Hi everyone. New member to the site. I've been a fan of Lucid since its debut. The used variants are becoming more attainable and I'm researching cost of ownership. Feel free to drop links to threads or material focused on service, software, extended warranty, gotchas, etc. I've already started researching insurance costs, etc. Looking at a 2024-2025 model year.
By HiSPL
Got a 92 745 Regina car. It idles really low. Is there a way to adjust for no money? I only need this to be semi-mobile so I can move it around my Empire of Dirt. I'm pretty sure the Cat is toast on it, as the 5th injector was just puking fuel all the time. I plugged that with JB weld. Also some hack put a different IAC valve on it, probably trying to get it to idle. It's badly spliced into place and I suspect its probably a Bosch IAC on a Regina car.
By rwilson
WTB A833 nice used 3rd gear. 70-up 29 tooth for 2.47 gearset. Must have 3 notches on the gear teeth tips
By NZHarrier
I have an issue with a car I recently bought. Granted, it's a 1998 Toyota Harrier 3.0 AWD, but I believe it's pretty much the same vehicle as the 1999 Lexus RX300 so im hoping someone will have some...
By ralphsmit
Hi all, I’m refreshing the suspension on my 2014 981 Cayman S (PASM, PDK), starting with the front. So far I’ve ordered: * Bilstein B6 DampTronic dampers * Tarett Club Sport camber plates *...
By Mudrig150
I'm looking to put 4wd in my 85 F150. I want to keep it around stock height and keep the factory tire size because I don't like the look of and have no practical use for larger tires. I've been...
By stuttgart1
Looking to trade a set of Sparco R333 seats with bracket and slider for a set of original 987/997 Cayman Boxster Carrera seats in beige color. The Sparco seat is directly bolt onto 987/997 and...
By Dustem
Haven't driven the car in several months. Leave trickle charger on battery. Electric holley blue pump is on switch in dash. Turned on pump no problem. Turn key to run position, no problem. As soon as the key is in start position I hear a click and dome light goes off. No power for lights or anything. After 15 minutes dome light comes back on, headlights work. Turn key to start again, hear click and lose all power. Battery is in the trunk. Wire ran to starter for power. Other than that all... Read more
By Ditcherman
Question for the more experienced around here… The TL;DR: how much benefit would there be to a trailer that self leveled - side to side - while rock crawling/off roading? Some conversations in the hardcore corner about trailering on Rubicon and Poughkeepsie got my wheels turning here. I’m also curious as to how many accidents are caused by a trailer tipping over on an obstacle, or going over an edge and pulling the truck with it or at least causing a very precarious situation? Would love... Read more
By The Truth
My auto wipers wipe every seven seconds when set to automatic sensing wiping and it don't use the automatic sensing function. Is there a way to reset the automatic sensing wipers? It looks like it...
By eldubb440
Big One Closer Than Ever: San Andreas Fault Now Hitting Record Tectonic Stress
By threatZERO
Hey guys, I am considering a *VIOFO A329S *with the Starvis 2 sensor or the *BlackVue Elite 10* 2CH. Vortex radar did a great video review on these two but wondering what the Porsche community...
By Jarlaxle
I...may not be selling my 73 Duster after all. I might be fixing it...so I want to avoid the screw-ups that result in thrown tools. Current setup is a Magnum 360 with an Edelbrock Air Gap intake, AVS carb, bogus 6bbl air cleaner, and stock hood with a Demon scoop. I want to replace this with a flat hood...but that Air Gap intake is tall. The question is: will the Air Gap intake clear a stock Duster hood? It's not clear with the current setup, but it looks like it would be VERY close. Anyone... Read more
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.