1953-56 Ford F100 3d Scan
By Hughmullersa
Hey Guys hello from South Africa I am currently busy with a Right hand drive 56 F100, I been trying to source rear fenders locally, to no avail. and right now with the tariffs its really now viable...
Discover
News, forums and creators
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
Latest threads
Filters
All publishersCorvetteForumRennlistIH8MUDFord Truck EnthusiastsFor B Bodies OnlyFor A Bodies OnlyMBWorldClubLexusRamForumAudiWorldJaguar ForumsLucid OwnersCivicXTurbobricksClassicBroncosSVTPerformanceGenesis OwnersMazdas247RX7ClubHonda-TechNorth American MotoringInsideEVs ForumEvolutionMMy350ZFT86ClubRenntech
Installed lumbar in my passenger seat, never had it.
By RTM
After installing leather inter, new seat foam and replacing the bad lumbar on the drivers seat in my 2010 F150. I just had to upgrade the passenger seat with lumbar. So much better having newer...
different front suspension??
By Zorm71
Ok, I know folks are changing out the factory stuff with the crown vic front end, but anyone try anything else? I recently picked up a complete drivetrain out of a 93 T-bird. The engine is still...
Kentucky Truckstock 2027--Pencil in October 21-24
By Doc
Now that the Pennsylvania TS is on the calendar (and I hope to attend), I'm gonna throw out a Kentucky Truckstock at my place in Blackey, KY. Pencil in October 21-24, 2027.
OBS Dash install question
By 1975mg850t
The answer is probably already here, but hard to find. We have my dash removed and refurbished. The skin is still separate from the inner dash. My helper is challenging that we should install...
forscan help
By tjc transport
i need to load licensing key to reprogram the key fobs on my 21 F150 after the battery died while i was down for a month, but it has been at least 6 years since i even opened forscan and can not...
2002 F-450 Super Duty drivers side front fenders.
By F350GUY1997
I'm currently working on a new-to-me '02 F-450 that I'm about to pull out the blown 7.3L and replace it with a good one. It needs a driver's side front fender while I'm at it. Who's the go-to...
Radio questions
By Clmsnfan
In my later years I've kind of grown an affinity for the touch screen radios in modern vehicles. I was wondering if anyone found a direct replacement for the 2012 f250(mine is a lariat) I've been...
Need Recommendation for Tonneau Cover
By RomeK2
Hello all, I was looking at tonneau covers last year for my 2024 F-250 crew cab with 8 feet long bed. I had decided on a PowertraxPro XR (it's electric power retractable with remote). I believe...
Aluminum Checkerplate Floor in 53 M100?
By Olboy
I’m strongly considering putting an aluminum checkerplate floor in the bed of my 53 M100. I want to be able to still use it as a truck so the fancy aluminum floor boards are out. A fancy wood...
3d printed parts
By Sags
Anyone using a scanner/3d printer to recreate various parts? So far I've rebuilt the door locks for the 1980-1981 trucks, (2 pc design to replace broken ABS slider), designed a tray for the busted...
1989 F150 Lariat XLT heat/ac only blows out of defroster and floor vents
By Esallee1
Hello, i recently purchased a 1989 F150 Lariat XLT with the 302. I have an issue with the heat/ac i can only get it to blow out of the defroster or floor vents regardless of where i switch it to. I...
A Little Bit of as Puzzler...
By Ltngdrvr
Left turn signal, rapid flash of dash indicator, right turn signal indicator flashing normal speed. You'd think it was a bulb out, which you'd think would give a message pop up. Well, no bulbs out,...
1987 f350 6.9 IDI c100 connector Pinout
By AbeTroyertheAmishPresident
I'm trying to find a pin out for the main bulkhead connector on the firewall of the engine compartment near the drivers side. I can't find anything anywhere.
leaf spring installation 03 ranger 3.0 xlt
By dbuchanan
Help...cannot for the life of me get the bushing to line up to put the bolt thru on the main eye. it seems to come up short. I followed procedures by putting in rear shackles on first but then the...
'77 F-150 — frame-off, 460, and a long way to go
By RiggsBuilt
New here. I've got a 1977 F-150 in the middle of a frame-off, and a 1997 F-250 that gets driven while the '77 doesn't. Where it stands: it's apart. Frame-off, 460 going in, and bodywork ahead of...
New here — '97 F-250 HD crew cab, 7.3, working through electrical issues now
By RiggsBuilt
Been reading here a while, finally made an account. Truck is a 1997 F-250 HD crew cab 4x4, 7.3 Power Stroke, E4OD, Dana 50 TTB up front and a Sterling 10.25 in the back. About 172,000 on it. It's a...
Low beams
By joshp23
I have a 2017 f250 lariat it’s a 6.2. All of the sudden the low beams won’t work unless I have the brights on, the bulbs are good. When I turn the brights off the low beams come on for about 3...
2021-2023 Gen 3 Raptor Owners: Center Bumper Light Kit With an Amber DRL Glow
By MandRautomotive
For 2021-2023 Gen 3 Raptor owners, this is our center bumper light kit. The pods have an amber DRL backglow that matches the Raptor's amber accent lights. Image: ...
Would you still check bearing clearances?
By 90project5.0
Now that I have the ability to pull the motor, I decided I might as well buy the one last part that wasn’t going to be replaced, the crank. It comes with new rod and main bearings. Would you still...
2024 Failed RF hub at 45k
By Binky7.3
My work F-150 started to develop a hum a few months ago and it's progressively worsened in the time since. I would only notice it when the steering wheel was off-center to the right. After a quick...
12V Wiper Options
By Ranger1976
Hello Group, I have a 49 F3 and I purchased a Dakota gauge cluster for it. I also purchase a 12V wiper motor kit but due to the depth of the gauge cluster, it doesn't seem to fit. Has anyone found a...
Tires & suspension upgrade.
By thebogeyman
Vehicle in question is a 2024, F350 6.7L, short-bed, platinum trim. Right now, stock suspension, stock tires & rims (20"), no lift. I do not plan on installing a lift either - at most, I may do a...
oily residue around slip yoke on rear driveshaft
By fordman19762003
2025 F150 4x4. I noticed there is a dark colored oily residue coming out the back of the dust boot where the rear driveshaft goes into the back of the transfer case. When my wife came back from a...
Forums & communities
110 listed, 26 connected and bringing in items.
Suggest a source
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.