News, forums and creators
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
Latest threads
1983’ mini-crawler RN48 “Clementine” Build
By mesa man
Finally Inspired enough to start a build thread on this beauty I scored a few years ago by mere chance!
Would check engine light affect GPS autolift?
By bradortho
I just had the Aeroflow Dynamics F1 exhaust with 200 cel downpipes installed which sounds incredible btw. I have a check engine light on after the install. My autolift would forget to lift every...
C207 Coupe Bi Xenon issues
By iMa3t
Hi all, I have recently after buying a 2009 E250Cdi coupe, if it helps I think it has the amg trim as it has amg mats and even the sidestep is amg stamped. I have been having issues with my bi xenon...
2LT no power and smoking
By ccasteel
My son in law had a cracked head replaced less than 1000 miles ago. He ran out of diesel one week ago. But it ran fine for the next week. Two days ago it made a fizzing sound (almost like a pop can opening) and lost power. He had it towed to me and after sitting a couple days we started it tonight. It runs rough and barely stays running with the accelerator fully down. Grey smoke was pouring out the back and some under the hood. The drained oil has some bubbles in it, but is not milky in any... Read more
OBS Dash install question
By 1975mg850t
The answer is probably already here, but hard to find. We have my dash removed and refurbished. The skin is still separate from the inner dash. My helper is challenging that we should install...
Model show!
By niceolddart
I'm going to my first model show with an old friend & 2 other guys Saturday. We're bringing a couple models each to display & hopefully mine won't be too bad compared to some others. I've seen stuff guys built on this site & some on You Tube & there is some pretty damn good builders out there. I will get better over time, I hope, but I am pretty excited about going. It'll be cool to see some of the builds & maybe get some ideas while I'm there.
Steel wheels
By Davidsel47
Im thinking of getting some steel wheels for my 100, just basic black steel. will they make a big difference in fuel and performance?
early-80 FJ45 LP chassis
By cruisermatt
Rusty Canada frame. Still straight and could be used for a beater 45 build. Rear spring perches are gone (last shop knocked the rivets out) but I would retrofit the later bigger bushing perches (available new) as an upgrade No VIN Located in Orlando Asking $300.
Is my harmonic balancer gonna explode?
By theglobb
I got a real crust-bucket of a 60 for free a while back. I'm about to cut it and turn it into a flatbed pickup truck but before that, there's a mechanical issue that worries me. The crank wobbles, it has done it for the past 6,000 miles or so. Obviously this can't be a good thing but I've never dealt with this before, so I'm wondering what it may be. a video is below My guess is the harmonic balancer is failing but I'm wondering if anything else (other... Read more
What's a 2LT worth in parts?
By DangerNoodle
I pulled the ole 2LT from my 70 for a swap, is it even worth trying to get rid of or worth much in parts? If so, what would you think fair value would be? It's definitely low compression but I have ran it. About 190k miles, from a '92. Fully dressed, 100% complete with harness. Thanks!
A journey with my boys- The Elf Barn as I call it.
By ceylonfj40nut
Been on Mud for a while. Have the addiction. Done a few projects in my driveway and on my back. Have a few Cruisers. My boys are at an age that is right to get them confident in many things in life thru wrenching. My dad taught me so much. Watching and doing alongside. Not to fear much. Dive in. Time to pass it on. This hopefully shares our story about our journey in time and all that happens in our wrenching cave. The Elf Barn. My Home garage was hard to get things done. Bought my last... Read more
Looking for OEM headlights, 2008
By Davidsel47
My daughter hit a deer and im looking for a used set or new set of headlights for a 2008, can anyone point me in the right direction?
Potentially purchasing a 1970 land cruiser
By EmptyLord
Long time toyota guy ( I have 5 first gen Tacomas, a 1st gen tundra and a whole heap of mr2s.) but recently got the chance to buy a 1970 land cruiser and I'm in the research phase of this, but here is there details - It runs, it drives, current owner has never taken it out of low gear since buying it years ago, its got a jeep plow on it that the current owner installed and only used on his lil property. the rear of the body is pretty rotten but my first visit to go see it, the frame looked... Read more
DME advise learned the hard way
By Titliest47
OK, so I've been trying to diagnose my electrical non-start issues. The hardest part has been finding the correct wiring diagram. I have a very early 2001 996 Cab / Tiptronic car. It seems the...
rebuilt 69 Corvette engine for sale,,,
By Alan didit
69 stroker motor completely rebuilt on engine stand, with everything to rebuild it completely again, with trainy and pulleys, and everything down to the pedals...I have lots of pics and video if your...
What Sure Grip Unit Are You Using?
By JG71B
Im taking my cone style SG unit out and wanting to upgrade. Been looking at the Dr Diff sure trac2 and power-lok units. Who has used these recently? Pros/cons? Other options? Running a 71 B body, mild 383, 3.55's, mostly a driver/weekend warrior kinda thing. TIA
MacMulkin Chevrolet
By JMelks
Just purchased a new GS from MacMulkin. Impressive customer service and responsiveness. Wow.
forscan help
By tjc transport
i need to load licensing key to reprogram the key fobs on my 21 F150 after the battery died while i was down for a month, but it has been at least 6 years since i even opened forscan and can not...
2 Michelin Latitude Tour HP tires used for 800 miles 265/45 20 Macan GTS
By varsorama
Purchased a CPO Macan GTS and they installed these prior to purchase. I upgraded to a different tire so these fronts only have like 800 miles on them. Date code 10/26 Not going to bother taking a...
Over sensitive safety codes - how to adjust?
By Rusty1992
2024 Q5: when driving solo, and I place anything on the passenger seat, the safety warnings - seat belt and airbag alerts go off. When I have someone in the passenger seat, with seat belt on, if...
New Air Filter, oxygen sensors, and engine comp fan for 996
By varsorama
All items are brand new, price is for everything as a bundle. Should fit all 996 models but please confirm part numbers. I think the oxygen sensors only fit the 99-01 3.4 models 1 OEM Hengst Air...
D2 Menu Switch 4D0919721B installation
By toomanycars
I'm replacing my menu switch and can't find a good description on Google or YouTube I have removed the side trim panels but need help with raising the console so I can reach the switch. Does the...
Forums & communities
110 listed, 26 connected and bringing in items.
Suggest a source
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.