Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Bimmer32
Could someone give me an estimate of a vehicle in this condition? Seems to be garage kept with excellent inside and outside. No wrecks or accidents. Just not driven that much in the last 17 years!
By Ltngdrvr
Left turn signal, rapid flash of dash indicator, right turn signal indicator flashing normal speed. You'd think it was a bulb out, which you'd think would give a message pop up. Well, no bulbs out,...
By AbeTroyertheAmishPresident
I'm trying to find a pin out for the main bulkhead connector on the firewall of the engine compartment near the drivers side. I can't find anything anywhere.
By dbuchanan
Help...cannot for the life of me get the bushing to line up to put the bolt thru on the main eye. it seems to come up short. I followed procedures by putting in rear shackles on first but then the...
By mystummyhurt
Hello all, I have read through many of the threads on here about the dreaded front fender tab / rocker panel damage. Not sure where along the way this happened, but looking for ideas to get the front...
By mbp
Hello. I have a set of working 69 seatbelts. I know that the age probably makes them not much more than a decoration but I would like to dye them and freshen up their appearance. Not even sure what...
By RiggsBuilt
New here. I've got a 1977 F-150 in the middle of a frame-off, and a 1997 F-250 that gets driven while the '77 doesn't. Where it stands: it's apart. Frame-off, 460 going in, and bodywork ahead of...
By andre sinclair
Wanted 1993 Rx7 ABS delete kit let me know if you have one for sale. thank you.
By burrpenick
Happy so far, dealer had changed the oil recently and I just completed my first on. The tech way overtightened both the drain plug and filter, and did NOT replace the drain plug washer. All good though as I have plenty of experience. I hope to have reset the service minder to 5K miles. Was VERY happy to find the drain plug inspection plate- my last Ford Focus didnt have that and the entire pan had to come off. Is there any other drive MODE options other than SPORT? Any tire recomendations... Read more
By racerjoe
12:05 Garage- 70 Duster build After trolling this page for quite some time, I decided it was time to share my rebuild with everyone. Dont let the title of the thread fool you, this isnt a high end shop building a car with an unlimited budget. Its a one man show in my home garage. Along with my love of Mopars, I also enjoy the sport of triathlon. 12:05 is the time it took me to complete my first Ironman triathlon. If you dont know what that is, look it up. I wont bog this thread... Read more
By Rhettvette
Looling for a Left rear inner fender liner for a base C8.
By POPO AGIE
Today I ordered an FJ60 rear axle housing to convert to a full floating axle. After researching what it will take to modify the frame it looked like something that I have the skill set to accomplish since I did my own reverse shackle set up. After weighing the cost of different options to install a used full floating that was quite high to have to replace the shafts. The next option was to buy the kit to convert but would have RCV shafts and was almost as expensive. Then I found out I... Read more
By Krooser
Good video from Weingartner who does a good job at being impartial with his tests. Perhaps this head isn’t what you want for your mega cube big block.
By Newbomb Turk
Here are the part numbers for 6% over drive pulleys. I thought just one pulley was part numbered for a big block but evidently both are big block pulleys. They absolutely will fit a small block you just need to shim the pulleys for alignment. Well crap. I don’t know how to rotate the picture but you can still see the part numbers. Sorry about that. Maybe a Mod can go in there and flip the photo for me. Edit: and I see the crank pulley is a two groove. Damn. I need to... Read more
By 69XR7
on a non-AC car - mine is a 72, how is the cable for the air door that connects to the C-H temp wheel routed? the AIM makes it look like it goes from the air door in front of the heater box, but...
By CrankMyHawg
I found the source of the horrific rattle on my 1994 940T wagon, the resonator is totally fried. https://imgur.com/a/cA0JXBc For the amount of work to get it off there I'm considering doing a complete exhaust replacement. Does anyone make/sell a decent off the shelf exhaust system in the U.S.? My initial searches haven't been too fruitful. There are some nice looking options coming out of Europe but the international shipping is a real downer. Car is bone stock, typical maintenance items handled and... Read more
By am911pm
…unless you’re parked in your driveway. iPhone Duo fits snuggly without a case between lower dash and center console shifter trim. Rest lower edge of Duo against trim then gently push top edge of...
By NAV8FTW
Has anyone done this? Comparison vs resonated factory midpipe? I currently have a factory exhaust with a deleted resonator but likely going to get the Borla axle back. Wondering if it will be too...
By Dkruse
Looking for a passenger door clear glass and chrome piece for a 1967 barracuda fastback
By captainva
Any of y'all see this? a few blocks from where I used to work House explodes in Virginia as police try to execute search warrant for suspect setting off flare gun - WTOP News A house in Arlington, Virginia, exploded Monday night only minutes after police posted on social media about a suspect setting off a flare gun inside a home. wtop.com
By TAGMotorsports
*Image: (https://tagmotorsports.com) Black Friday Deals Are Live at TAG Motorsports, Now Through November 29th.* Our Black Friday sale is on now across the TAG online store. Whether you've...
By nguy2175
How or who do I report a member who is trying to sell parts but is a trying to scam us?
By KFC1
I’m shopping for a used CR-V. The 2007-2011 cars are noticeably cheaper than the 2012-2014 generation, so I’m considering them, but I keep reading about oil consumption, especially on the 2010-2011....
By Serp0421
Looking at dobinson 2-2.5 lift on my LC. Are the torsion bars and diff drop necessary?
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
