
Ranger Roadster (lowered)
By twistedmetalcustoms
Image: Image: Image: Image: Image: Image: Image: Image: After 15 years looking like a prerunner. I bought a DJM 4-5 lowering kit. new rear bumper from Amazon.
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.

By twistedmetalcustoms
Image: Image: Image: Image: Image: Image: Image: Image: After 15 years looking like a prerunner. I bought a DJM 4-5 lowering kit. new rear bumper from Amazon.

By Mr.Duncan
Hey guys! This thread will be to document any work I do on this truck. This would be my first Ford, and first Truck! I've owned classic cars before, but normally its always been air-cooled...

By shepchristian
Looking to sell my truck. Photos below attached. Any advice on places to post outside of Facebook or this forum? Image: Image: Image:
By K9Kodi
I’m fittin to get rid of chrome. In will have new bumpers in time, but until then, I’ve been trying to find a vinyl wrap for bumpers and mirror cap that are close or close enough. If I can’t I’ll...
By MXer746
Hi all, Mabey someone can help. I've got a 2010 F250 SD 5.4L and I'm getting a P0500 only, that's the only code. My speedometer is dead, and my door locks don't automatically lock, the airbag warning...

By columbia1spring
1965 F 100, 300ci, in-line 6 With an HEI Conversion Members, I have an HEI, large coil in cap conversion by CRT Performance. The set up is all black and it works and runs amazing! I went on line...
By flanneldan9
Hello all, I have a 79 150 4x4 4-speed with a 400 in it. The truck is very original and runs great with about 85k miles. Still, it shipped from the factory with pretty low HP, and I figured it could...
By Merle301
Drivers side window control cluster , window buttons stick in whatever direction they are pushed,, going in for service, had the mirror control switched out a week ago , dont think anything service...
By TMartelle
I have a 1978 Ford F150 with the 351m that all of a sudden wont idle and backfires at higher rpms. I just did an auto to manual trans swap, and it was running fine before but now is acting up. It...

By Kibbers
Good Morning/Afternoon/Evening to you all! I recently took my ambulance out of "Mothballs" to drive it around a little and found the axle seal on the drivers side to be weeping slightly. I looked...

By Puk
[img alt="What is this part is on my 2003 f-250 6.0. It is on top off engine on passengers side and it’s leaking coolant from right side hose...

By Christopher2
Look what I found doing a little fall cleanup—a pair of Smithy’s mufflers from Ernie’s Speed & Custom in Iron River, Wisconsin. Still in the box since 2005! I knew I was saving them for something. 😂...

By 66F250_4x4
Hey, 1970 429. Water is pouring off this corner of the pan while the engine is running. I can't see the direct source. All hose clamp locations look good. I am assuming the pump, but cannot see...
By samuel4wolfpack
So I am researching replacement heater cores for my 1996 F250 4x4 with the 5.8, and there is A/C in my truck. It appears from the list that RockAuto provides, an OSC brand is listed where the tubes...
By Raymond
Looks like S&B is coming out with an intake for 2020 to 2027 trucks. S&B Intake Manifold & Turbo Inlet for 2020+ Ford Super Duty, 6.7L Powerstroke...
By 91bird
1995 F-350 7.5L / E4OD / PSOM — can someone confirm these rear VSS resistance readings? Troubleshooting an intermittent E4OD shift issue and a speedometer that waves slightly around 65 mph. ...

By zacT
Which heater hoses are the inlet and outlet (long hose and short hose)? And which ports on the firewall are the inlet and outlet port (top or bottom)? Thank you. Image: Image:
By donmanmdm
Hello, I replaced the fuel pump assembly on my rear tank, i only have the rear working atm. My gas gauge didnt work before but its because there was no flaot. So when Installed it, it went from below...
By NJ_Phil
Truck has done this since day 1, before and after a few mods. Trans runs great, shifts smooth, fluid always clean, fresh oil change, etc.. the only problem is RPM flare during a 4-3 downshift,...

By 51504BAT
Note mine and know nothing about it but what's in the ad. Couldn't sleep this morning so cruising through Market Place and this popped up. Seems like a perfect addition to GB's Jail Bar Ranch? 1943...

By Shortbox4x4
Here is a pic of my new seat. Very happy with it. For one it's very comfortable. Was going back and forth with having the center section to be black but went solid red with black lower trim. Either...
By bdinger
Hi All, I bought my 2020 3.5 EB XLT 302a new back in July of 2020. Fast forward to now and it has 105k on the clock and I'm thinking of trading it in on something new. My biggest gripe? Ride...
By CathedralCub
Hello All, I had occasion to test drive a brand new Transit 150 3.5NA SWB RWD . In short: it was a pig. Light throttle everything it did felt sluggish and it felt heavy. Weather was beautiful,...
By inniss
I have a 09 e450 6.8 triton motor. Had b1s2 02 sensor melt on the cat. the pigtail and sensor wiring . I have prodemand and looked up the original wiring to wire in new pig tail but the wiring on...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.