Lowest water drain on 302
By 90project5.0
As title says, I’m looking for where is the absolutely lowest place to drain coolant from? Would it be the freeze plugs on the side of the block or water pump? Within the next two weeks is go...
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By 90project5.0
As title says, I’m looking for where is the absolutely lowest place to drain coolant from? Would it be the freeze plugs on the side of the block or water pump? Within the next two weeks is go...

By RedSoxAnt
Hi everyone, I’m trying to locate the former owner of this 2008 f350 king ranch with the 5.4 in it. It has spent its entire life in charlotte North Carolina. I’m hoping to speak with the previous...
By gadams999
I just got off the phone with Granger. Planning on picking up my truck Friday, but the finance manager said Ford is releasing a recall on all 2027s, but they don't know what that entails. Anyone...

By peezduk
Hello forum, Just wanted to make an intro and show my latest project. I have owned several F100 trucks over the years and just purchased this one to build into a daily driver. Its an ex military...
By scottz99
Just curious; how does the truck determine miles to empty? Does it have sensors similar to an RV holding tank, or does it just extrapolate off the fuel gauge?
By 90project5.0
90 F150 with intermittent wiper system. Every function works as it should (intermittent, spray and high speed) except low constant speed. Can the delay module cause you to lose only one speed and it...
By Shadowrider123
Any tips? I have a factory spray in liner and the 5th wheel prep package, I am not confident that the hook and loop is going to stick to the liner. Has anyone used the hook and loop on a...
By Dustin F450
I'm also part of a Tacoma board and a member bought spark plugs for his truck from Rockauto.com and claimed they were fake/counterfeit. He said they looked like genuine Denso but the electrodes were...
By Nevadasteve
I have a 2020 F350 w/ the 7.3l gas engine and when changing the serpentine belts notice the plastic bracket that keeps the fan clutch electrical connection from rotating is broken. I did a temporary...

By oldbird1965
After twenty years on the 7.3 forums I now have a 2016 F450 6.7 because I was stranded in Rock Sptings, Wy for 11 days after blowing up my 7.3. After a 47 mile tow job to a KOA I started shopping for...
By MrFrost
I did try searching for similar threads first, so hopefully I didn't miss one. I am trying to ensure that the 12v plug in the lower storage compartment under my middle jump seat turns off with the...
By Josh kirouac
2006 6.0L just replaced all 8 fuel injectors with oem injectors. the truck fired up once right after replacement then i shut it off to finish up a few things on it and now a few hours later its a...
By runnermatt22
Own a 1966 F-100 that originally had a 3.9L 240 and swapped with a Mabbco Ford 4.9 300 Premium Long Block 1968-1986 Carb. I also have the Holley Sniper Autolite 1100. Here is the issue: The...
By Cant.Dan1968
Im looking at new trucks now since my 2009 Lariat is about to hit 300k and things are stating to rust off the bottom. I test drove a 2026 Tremor with the 5.0 and really liked it, hated the...

By Wolfbox
Hey Wolfbox Family, SEMA 2026 is right around the corner, and if there is one category that always steals the spotlight in our forums, it is lighting. Whether you are building out an overland rig,...
By Tinnermancarter
Hello all, I recently had some work done to my 2015 6.7L 350 2wd. I had the turbo replaced, a delete, and a cp4 contamination kit. After all that work, there has been a weird humming noise...

By Endliss
Like title says I have an 2010 f150 xlt 6.5 ft bed that was rear ended when a cop was chasing a guy in a stolen Benz they deployed stop sticks he hit em had no headlights on at 3am the sticks caused...

By 77F
I have a 77 F150 with 300/4.9L that had Factory AC and the compressor and upper part of the bracket were removed. I am having trouble finding what parts I am missing. Any help would be appreciated. ...

By Turbogus 1
*Hi guys, now that 'Black Betty' has a potential buyer I was looking her over and noticed the inner spring of the twin Carburator Throttle Return Springs has gone MIA* Image: *I went by NAPA...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.