2024 F350 Lariat tail light
By Paul Kujawa
I recently put a small hole in my right rear taillight lens. I am not going to put epoxy over it as some people have suggested to me.. that'll drive me nuts when I see it. Anyway, I see Ford has...
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Paul Kujawa
I recently put a small hole in my right rear taillight lens. I am not going to put epoxy over it as some people have suggested to me.. that'll drive me nuts when I see it. Anyway, I see Ford has...
By Travis44
2013 ls 460 base. Cold air at idle. The antifreeze was low i filled and no change

By OutMotoring
[img alt=""]https://mcusercontent.com/1ff8e8490c8b8eca73d12df95/images/6d6b1536-c431-d647-8bb0-72e2a4df81be.jpg[/img] (https://www.outmotoring.com/) *About Us...
By gtejegar
Hi everyone, I'm having an issue with the rear door of my Volvo 940 after replacing the exterior door handle, and I'd appreciate some advice before I start taking things apart again. Yesterday, I replaced the exterior handle, and everything seemed to work perfectly. I tested opening and closing the door several times from both inside and outside, with no issues. However, as soon as I locked the car and tried to unlock it again, the door became completely stuck. Here's what I've noticed... Read more
By dickkeane
What do people do to improve front suspension on these old trucks? I plan on putting front disc brakes on as well, so maybe I can kill two birds with one stone on a swapout. Can anybody recommend...

By JimVonBaden
I just ordered a 2027 Q3, due to arrive in Portugal in February. It is a FRD e-hybrid 200KW 6 speed auto. It is in Tambora Silver. 62K Euro list, paid 53K Euro. Internet photo: [img alt="2027...
By Justsiff
My B9 Audi S4 Avant pinged a warning light after hard acceleration saying: "Drive System Fault take to workshop" It has since then been into a garage and had the boost pressure sensor replaced. It...

By Rocketman1980
Whenever I purchase a new car I always get a replacement set of floor mats. I tend to keep my cars for a long time and want to ensure I have a replacement set for the future as they wear out. When...

By MPalmer
https://www.clublexus.com/articles/2027-lexus-nx-goes-hybrid-only-gets-more-standard-equipment/ Image: Image: Image: Image: Image:
By 5.0 Hatch
Looking for a Billet Flow stock sized upper pulley. Probably not an easy find but i figured I'd try. I'd buy it or trade a 3.1 for it.
By Winecountry
As I read the thread it looks to me the Supercharged engines have more issues than the Standard V8. The exception is transmissions, the ZF is not as reliable as the Mercedes.

By hitmanforty5
This is probably a long shot, but has anyone run either of these exhausts and ditched the factory tip setup and attached an aftermarket set of tips to the axle back? Image:
By Anatta
Does anyone make a rubber gasket for the valve cover on a 300?
By tom991
When I turn my headlights on the right headlight doesn't immediately come on. I haven't timed it but it takes a little while to get up to the same brightness as the left headlight. I bought the car...
By THEBONE
I'm looking for the three pieces of trim that hold the carpet to the tailgate on the Ranger package. Two bottom pieces would also work. Looking for good condition or better. Original Ford only. I know I can buy reproductions, they aren't exact. Send me a PM. Thanks, Steve

By Beefcake-Racing
Today at the shop, we’re talking about the QA1 3/5 Lowering Kit ! We installed this setup on our Lobo shop truck, and in this video, we break down the kit and show you how it looks on the truck. Check out the finished stance and see how this setup transforms the look of our build! QA1 3/5 (5/5) Lowering Kit on our 2026 Ford F-150 Lobo We install the Qa1 5/5 kit on our lobo shop truck. https://www.beefcakeracing.com/qa1-lk12-ff05/ youtu.be
By Timcstl
brand new master cylinder for is350 f sport. Bought for son in germany did not need it still in packing. $515 new

By Moyni
I recent bought a 94 940 turbo, one owner car that has been sitting in a garage for the past 6 years after its owner passed away in 2020. Its all in nice shape, good service records, good paint, etc. I am doing the obvious stage 0 work to get it to run, just wanted some opinions on what parts to get. I just replaced all the fuel pumps and filters since the gas was super varnished. The in tank sender was reading okay before I pulled it, now its a borderline open circuit (like... Read more
By beworthy3
The car sat for a little over 2 weeks. When I left it was hot outside, now when I return the lows are in the high 30s. I went to start the car in the morning and it had a loud consistent ticking...
By forest.frank
Does anyone have experience obtaining and working with the Brabus parts that comprise the lower front grille of this car?
By Jim Ward
Check out this video to see the progress on my 1972 Plymouth Scamp bought in northern Wisconsin. I started on this car the fall of 2024 and hope to have it done by May 2025.
By HALIFAXHOPS
I am looking for Bad dual point vacuum advances, let me know what you have will Pay $10 each and the ride.
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.