ductile iron bb
By Moparguy59
l have a nice set of these rockers They aren't galded and heavily worn inside Car had hyd cam /110# springs and never saw 6000rpm I'm at $235 Tim in iowa They aren't galded or abused Maybe 120 1/8 mile passes
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Moparguy59
l have a nice set of these rockers They aren't galded and heavily worn inside Car had hyd cam /110# springs and never saw 6000rpm I'm at $235 Tim in iowa They aren't galded or abused Maybe 120 1/8 mile passes
By mikemm
Q7 intermittent struggles to start Looking for some advice from anyone who’s experienced a similar starting problem with an Audi Q7 3.0 TDI. Vehicle: 2014 Audi Q7 3.0 TDI, 180kW. The engine...
By zezewins
i’m turning 16 soon and have been saving and have around half the money for a c5 i’m looking to buy it in full my parents are helping and i’m looking at a manual, i have driven manual before i think...

By C4KenP
GM 3849804 Holley List 2818-1 dated 482. For 1965 Corvette L76 327 365hp. Correct metering blocks 4094 primary, 4099 secondary. Correct Base plate 12r1856B. In great condition. Could either be...
By ShmunkedOutFR
So I am a new owner of a (pre-owned/dealership 2013) ES350 now it’s my second week of ownership and I have a few questions. 1. My side view mirrors done look down when I put it in reverse. i used...
By Jwhigga81
2018 Ram 2500 Limited, 6.7 Cummins, 68RFE, about 165k miles. Aftermarket FASS lift pump, preset tune flashed into the ECM (flash tool disconnected afterward), Banks iDash on the OBD port (installed before the first stall). WHAT HAPPENED • A few weeks ago the truck cut out at about 65 mph, coasted to the shoulder, cranked but would not start. The FASS pump stopped priming at key-on. It had primed normally before that. • Three FASS relays (original plus two new) changed nothing... Read more
By DeafSnipez
remote start hood latch connection wiring harness. My truck was missing wiring and wrong hood latch by past owner so I try fix it up I found hood latch connection at store but I can’t find wiring harness on online. Also can yall tell me where it wire connects to?

By JayfromSD
I have a 1978 911sc 3.0 the fan housing has a crack in it, I did find a couple old posts about some guys that did repairs, I tried to contact but did not get any response, does anyone know of someone...

By AlanT_Eustis
VMP Supercharger Spacers — Predator/Whipple, 5.0 Coyote — $350. VMP supercharger spacers for the Predator/Whipple blower setup on the 5.0L Coyote. Specs are shown in the photos — what you see is exactly what's included. Local pickup in Mount Dora, FL, or email to discuss shipping. Email only: alanthompson1029@gmail.com . (Alan Thompson)
By beached_as
Hi all, Recently purchased a 2016 Q7 here in Aus which had a towbar installed but no trailer module connected. In the left rear panel I've found the plugs for the tow module which I have on order...
By Mturner777
1997 accord ex wagon 2.2 V-Tech Towed in for A water pump warranty Installed the ASIN full timing kit codes 73-1 and 79-1 came up car Runs like A top The ghost cyl #3 miss fire still haunts my...
By Rulebreaker
I just bought a wrecked 2010 extended cab. I found a donor truck the same color but it's a crew cab. Will the front door from a super cab fit my extended cab?

By Wagwan
Image: Image: Image: Image: Behind the driver's seat the carpet is soaked, I checked the passenger's but I can't tell if cold or I'm paranoid so I immediately thought ok clogged sunroof...

By paulm68
I am new to this forum so forgive me if I am posting this in the wrong place. I just converted my original CDR 23 to the new PCCM+ and am asking if the old radio is worth anything. I have all the...

By audi49
I recently purchased a ‘80 SC. It’s had a windows out repaint in its past. The alignment of the rear side window and how it mates up to the rear edge of the door frame is “off”. I’ve noticed this on...
By Sean J Blackburn
Quick PSA about using Rain x washer fluid on our trucks. It took years of consistent use, but rain x washer fluid left a gelatinous coating on the washer fluid sensor prongs. This caused the dash light to stay on for washer fluid even with a full tank. The way the sensor works is it measures a very small current in the washer fluid between the sensor prongs.With it gummed up it could not read the level. It easily cleans off but the sensor and grommet was about 10 bucks and mine was 16... Read more

By areenib
Seen a few different threads on brake noise but can't seem to find anything that describes what I'm hearing...a high pitched grinding/honing noise that only occurs after the brakes are warmed up...
By huntnfish48
My clutch linkage components are all worn. I welded and ground what I could but my swivel block on the z bar is further gone then I'd like to repair. Are you guys replacing with a new swivel block...
By Ksagun74
Hello, i got the codes P0138 & P0158. i have replaced both O2 Downstream sensors & it’s still happening. When i did the live data test with the OBD scanner it read the voltages .01 for both old and...
By bcabano
Cobb Accessport for Porsche 981 Cayman, Boxster / 991.1 Carrera/S/GTSECU Tuning (no TCU/PDK Tuning) Can ship from AZ. Was on my 981 GT4 - returning to stock to sell the car. Fits NA 991,...

By Funkdawg
My wife's 2007 ES350's steering wheel buttons were melting so I ordered replacement parts from Ebay. I initially ordered black but needed gray buttons. I ordered another pair (specified gray as the...

By earmand
Image: I'm trying to track down a rattle that seems to come from behind the passenger-side rear seat when the hardtop is up. I haven't been able to find anything obviously loose behind the rear...
By earmand
I have a 2006 Lexus SC430 with approximately 98,000 miles and am trying to track down an intermittent convertible-top problem. I'm interested in hearing from anyone who has experienced something...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.