Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By GTB/ZR-1
Had these on my 4RS. Trying the resonated version (getting old lol). These are the max HP version. I just put the non-Res on my car and frankly, these are not much louder. So not sure if juice was...
By Kamilo77
I ordered replacement rear Bilsteins from Roger. The spring perch’s are about 1/2” narrower than the factories. The full spring doesnt seat inside as needed. Anyone else run into this? Just checked...
By thenative1
Morning all! My first time posting in the 80 Series section. Have lots of wrench time on an ‘84 FJ45 Troopy and an ‘89 FJ62 but just starting the journey on a new - to me - 3x locked ‘97 FZJ80 (below). Lots for me to fiddle on/improve and on delivery, found the low-beam bulbs were dead so replaced them and in replacing the driver’s side, while fussing with the headlight housing, the grommet below seemed to drop out of nowhere. Looked hard for where it might have come from and examined the... Read more
By mikemm
Q7 intermittent struggles to start Looking for some advice from anyone who’s experienced a similar starting problem with an Audi Q7 3.0 TDI. Vehicle: 2014 Audi Q7 3.0 TDI, 180kW. The engine...
By retiredin93
I have a 2019 F250 and cannot get the brake controller to adjust to a higher gain. It was set on 2, but would not go up, I pressed the - button and it went to 0 and wouldn't go back up. Any ideas of...
By ModInJapan
Hi folks, Mod in Japan here. Putting an intake option for Lexus RC F owners in front of you, available from us now. Image: ...
By MrTrim
Well, if you’ve been following along with my project 67’, you know the previous owner is still searching for all the original parts removed when he built the car into a street racer. Up to this point...
By John1c
Hey Fellas, please recommend a shop in OC that can solve my AHC issue. The suspension sometimes go really stiff without me changing the comfort level. Thanks.
By Agent_York
Hey all! I'm looking into buying a C8 corvette but im concerned about parking. I live in an apartment. I have underground parking but the lot can be seen a little bit from the garage opening but the...
By 440 sixpack
Has anyone done the wiper blade recall? do they give you new blades or just look it over and tell you to get lost? Both my'22's are on it, but neither have a problem. they're ready for new...
By GTB/ZR-1
15mm Numeric Racing 5x130 spacers with extended bolts - $115 shipped. I used these on my GT4 to run different offset HREs. Threads all perfect, no issues.
By steveP911
Had our season ending DE for PCA Potomac at Summit Point this past weekend. Friday was volunteer day, with five sessions of 30 minutes each! Pays to volunteer! I will continue to say that I feel this...
By derk87
I bought my first 2009 lx over the weekend. Spent the past two days going over it and getting it inspected and everything is great and clean on it. Went over the whole interior and made sure everything worked. When I tested it the 4Lo didn’t engage but managed to get it to activate randomly trying it again. I was worried there would be steering or suspension issues since it sat with little driving the past 6 months but at the inspection everything checked out good. The frame... Read more
By Floydy
Decided to replace the scratched and chipped windshield on my 72 coupe. Popped the old one out without too much difficulty and starting to think through the plan to install the new one. I'm...
By johnnymat
900 mile Roadrunner road trip! 1970 RM21 project let the fun begin couldn’t be happier! Found an honest seller now officially in the club. Came with a drive train t5 440, 833 and 8/34 no idea of the ratio…hopefully get it running and mobile is the plan. Someone replaced both rear quarters, trunk pan, outer wheel houses floors, very solid not the finest work but… He gave me AMD bucket seat braces not sure how they go in and I will need seat risers has non matching Upholstery buck seats... Read more
By mikewelsh75
Brand new off the lot 2025 Laramie, Hurricane v6, 5,500 miles. Highway use only. Turned corner and... this... anyone else have catastrophic suspension issues and where do we go from here?
By jshelton7199
Many of you will recognize me from the last couple months trying to fix this problem. I've been through many many fuel pumps and none have seemed to fix the issue. This is what I did for anyone who's...
By sbilby123
Hello, my shift boot in the cab is torn and a little bit of trans fluid spreads out a bit by the shifter. I do have a new boot. My question is how does one reattach the boot without tearing up (...
By jws123
I need to replaced a badly damaged right rear door on my 2020 ram 2500 crew cab. From what I understand this truck uses a 4th gen cab and doors also looks the same. I looked at many 4th gen right rear doors crew cab and I see no diffrence at all besides the inernals. The part numbers on the outer door skin match up but the complete doors does not? Besides the internals if anyone knows what may be diffrent please let me know. The junk yard refused to sell me a door off a 2022 Classic saying... Read more
By planojoe
Selling my V1 and moving to a Uniden R8W. It is in perfect working condition, no blemishes, with all accessories. $200 shipped. [img...
By MissouriLC
A little over a month ago, I rebuilt my starter ( Late-night starter replacement... - https://forum.ih8mud.com/threads/late-night-starter-replacement.1384788/#post-16422574 ), replacing both the contacts and the plunger. The started in question is a Denso remanufacture 280-0169. FWIW, I replaced my fusible link and junction block at the same time. A week ago, I weird intermittent issue started. About once every 8 to 10 starts, the starter will crank a couple of times and then make a... Read more
By Reed Strickland
Hello everyone...looking forward to sorting out some issues with my 957 and it seems like this may be the place to make some queries. I have a love/hate relationship with my Porsche...sometimes...
By ProCycle
I've got my 8.4 UAQ installed. My only issue is the A/C does not come on. I have all 7 fan speeds, the foot/dash/defrost air control works fine. The temperature buttons adjust the red/blue graphic on the screen. I have the OEM HVAC control module, single zone bezel, the conversion harness checks out for continuity and correct pinout according to this post . The compressor never runs. Any suggestions where to look next?
By Scota4570
2007 2WD 1GR-FE VVT-i, I have been having codes indicating cam to cam and crank not synced for several years. I replaced the passenger side VVT actuator about 5-years ago and no codes or check engine lights until recently. (The dealer told me the car was scrap!) I recently replaced the driver's side VVT actuator and it made the check engine light pop up immediately. Oh yeah, 250,000 miles. The car is in excellent shape, runs great, no rust, and looks good. I pulled the inspection... Read more
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
