Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Z06Alex
Hello everyone, I'm looking to purfchase a C5 Z06 roller or project car. Must be a clean title car and have a straight body. I'm OK with engine or transmission failure as I have a built LS for the...
By Stavros Koushis
Image: Image: Hello everyone, I own an A3 8P1 2005 1.6 fsi and I want to replace the 1.6 fsi clutch with something a little beefier bc after 2 years of mountain runs the springs have become...
By ATL Truck Guy
Plus more solid door close. This mod works well. I do this on all my vehicles. Prep surface before application. 80’ needed for all 4 doors. Hinges need it more… Disclaimer, the doors will require about 25% more effort to close.
By dk6666
Gymnastic Shorts: A Buyer's Guide for Training and Recreational UseFinding the right gymnastic shorts (https://royalfits.ca/collections/gymnastic-shorts) comes down to one core requirement that...
By MaxVDJ79
Hi all, I've got a 2018 VDJ79 workmate and I'm wondering if its possible to fit the GXL factory diff lock diff centres to a workmate model. I was planning on buying some diff centres from the wreckers with the factory diff lock as it would be much cheaper then buying for example Harrop E lockers. I'm now questioning whether its possible due to the diff housings potentially being different. Are the GXL diff housings (Front or rear) different to the GX and Workmate diff housings? To... Read more
By M_Body_Coupe
OK, this truly is a 1st for me in this hobby of ours, but I just got a NEW MSD Blaster 2 coil, this is the epoxied one (part# 8222). Took the rascal out of the box, I give it a quick shake...what da????..."slosh slosh"...yeah, guaranteed this thing is full of oil!!! So I call the MSD Tech Line...the guy's advice was an abrupt: "not a real 8222 coil, send it back to the seller", and that's despite it being factory sealed, it's a NEW unit, all the markings look MSD..."could it have been... Read more
By Flashark
Thought some of you F-150 guys might find this interesting. Alec from Street Truck Co. just did a one-year, 10,000-mile follow-up on his Flashark cat-back setup. The truck has seen plenty of...
By theworkerbee
So since I've owned the Cayenne the left side door lights don't illuminate when I open the doors and nor do the interior lights. I think this confirms that the car doesn't know that the doors have...
By wiging
The Atlanta Airport Parking guide covers parking options at Hartsfield-Jackson Atlanta International Airport (ATL), including hourly, daily, economy, park-and-ride, ATL West Deck, ATL Select, and...
By Papa Tiger
One of your questions jumps out to me. If the Battery is getting older, the computer will start shutting stuff off. I believe it senses a loss of Amperage / Voltage around 12 volts. It shuts down...
By GJT
Hi, I have joined the forum group. I am about to purchase a F Type 2021 - R Dynamic in Eiger Grey that has a FIXED rear spoiler. I am looking at seeing if anyone is out there and would be wanting to...
By SafrdA
Hi, I’m looking for a C8 Z06 1LZ. Having the Z07 front bumper and rear wing would be a nice bonus. I don’t need the front-axle lift system; color and other optional extras aren't a priority,...
By 2 old for this
I have totally forgotten how to diagnose a 240 cruise control. And can’t find any info. The car is a 262 Bertone that has a 1990 240 wire harness and rear axel. Thanks in advance.
By 7necharger
Need help restoring complete rear of 70 charger. I am installing new rear frame rails and need measurements distance between spring bracket end where it should connect.on the book it says 57 1/8 but I have noticed its not coming on rocker notch where it suppose to be. To me it looks off about 1"".
By alanroberts50
The shop said my “saddles” were worn and showed me these so I took pics for the forum to give me an opinion.i don’t really notice anything in ride handling but that’s a bit like asking me to tell...
By tobywood13
Morning all, I just tried to start my Jag to go to work, but it wouldn't start. The engine turns over, but it doesn't make the usual uh-uh-uh-uh cranking sound; instead, it's a constant whir almost...
By 66 Sat
I have a question on Internally balanced engines vs Externally balanced engines. I understand the basic differences but don't understand how the actual balancing process works with External balance. 1. Is the rotating assembly still balanced to a certain tolerance? Surely pistons and rods are still balanced the same as with internal? 2. How can a generic "one size fits all" flexplate, flywheel or damper be installed without this itself needing to be specifically balanced? As they are on... Read more
By Bump It Offroad
Four hours left! https://www.blipshift.com/products/90s-and-80s No affiliation.
By iksang
Hello, Is it possible to change the F Sport cluster on the instrument panel of a vehicle sold in the U.S. from miles to kilometers? I'm thinking of buying a used one and am wondering if this is...
By OrangeCali16
Hi all, I have a 2013 GTS that I has given me a terrible headache since I bought it. Been resolving issues one by one but this particular issue has me going around in circles. Sharing here in hope of...
By TheFinestImage
As a back up I bought an EOS splitter for my 2014 Stingray. Never had a need to use it . Bought it a few years ago for $900.00. Price is lower today. I’ll sell this one for $500.00 FIRM. Still a...
By waz555
good day! would like to ask if the cayman R's guage cluster is the same with cayman 987.1 and 987.2 ? ( the outline of the cayman r guage is abit silver) the lens has some cracks and plans to buy...
By ThoughtfulOne
A few days ago, I saw this post on Reddit: https://www.reddit.com/r/cars/comments/aqflbu Anyways, before you read on, I would like you to read the post. The AWD transfer case appears to be sealed and cannot be serviceable. The Magna Actimax when used on the BMW xDrive appears to have been known for failures. It is looking like there may be issues down the road for the Genesis HTRAC versions, as they use this case. Anyways, the original poster was a Hyundai tech, and I've interacted with him... Read more
By FDiesel01
Got home from a drive today and noticed a leak coming from underneath the passenger side of my 1999 C5 Corvette, I've attached a picture for reference. Does anyone have an idea what it could be? ...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
