Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By OGBeno
Figured this section needs this addition. Installed new headlights. RH is OEM. 1 left in the country and it will most likely discontinue. LH was Depo aftermarket. OEM RH headlamp assy. What’s they looked like: Both installed. More better. Roadtrip commencing tomorrow.
By rnl
I have a 2012 991.1 C2 with 115,000 miles. I am the original owner.The car displayed a yellow drive on fault notification. I shut it down, connected the scanner and saw that at the car recorded a...
By mattd1205
I’m considering getting IPD sways for my stock 1991 245. I’ve got a pair of IPD sways on my also stock 1990 744 and absolutely love them. The car feels planted and sure of itself while my wagon just wallows through corners. I’d love to have the same feeling in my wagon. I realize there’s only so much I can do with the difference in ride height and totally different suspension between the cars but I figure that Ipd sways would be a nice upgrade but I’m unsure which set to go with. Any... Read more
By WTM75
Hey Benny I’d like to get a price and est. edit time on a set of the Mopar fitted rubber floor mats for a 2026 Ram 2500. It’s a crew cab with front bucket seats. I think the part number is: 82215767AC But you will need to verify. Thanks Wes
By 12bit
Anyone have a pic of the wiring harness routing near the o2 sensors on a 97? Can't figure out which connector is for the upstream vs downstream sensor.
By slyply8850
Hi Guys, I could use a little advice. I was replaced the wires from my headlight relay kit that run from the alternator to the relays for the kit. (The one I had on there was working but too short to route across the firewall). When I was finished, I put the battery back in the car, hooked it up and when I tried to start it, when I did I saw smoke coming from under the hood. By the time I disconnected the battery, damage had been done. In my haste to figure out what I did wrong, I took the... Read more
By 1crzydrvr
Hi everyone! I REALLY need some advice. I have a 2013 Ram 4wd with a 5.7. I have several codes showing. Mostly showing low voltage issues. Codes 2122, 0562,0073,0750,0222. I have swapped both speed sensors and checked all fuses and relays I can. I’m stuck on limp mode and reverse is locking up. A reset of the battery will reset reverse for a min but the truck will lock up again. It also immediately goes limp when I shift into drive. Any suggestions will be greatly appreciated. Than you
By BostonJoe33
German cars and German dogs in this house😂. Meet Frisco, patiently waiting for our Sunday hike. Image: I have a beater SUV (2025 VW Atlas Cross Sport) 100% dedicated to him. Image: Image:
By mb1
I drive a 2025 718 Boxster GTS. I've been using my (wired) iPhone 15 with only some minor Apple CarPlay issues since summer 2025. I purchased an iPhone 18 Pro last week, and my car won't recognize it...
By Bobby
I was doing a little reminiscing today. I have now had the car for two years and five months and it's at 33,000 miles. As is true with any Internet forum, there tends to be a lot of complaining and negativity here. I would like to address some of the things where I've seen major improvement. This is not to say there isn't room for additional growth and improvement, but the car I'm driving today is significantly better than the car I originally bought. So next time you're about to write a... Read more
By Charger Too
1968 318 Engine: Do the exhaust manifolds require a gasket be installed when bolted onto the head? Thanks!
By Ascho
My lane change assist stopped working. I checked the settings and it is toggled on. I am currently paying for the Go Anywhere subscription plan since July 1 and believe the feature was working...
By 80JDM
Hey fellas, I'm admittedly new to this interweb forum stuff and I'm not sure that his is the right way to update a post I made earlier this week... I noticed that I only had one comment from about 70 views and thought that maybe I'm not explaining myself clearly enough. The image below shows the three rubber EFI hoses I need to locate and purchase. Otherwise I'm left to fabbing a set of custom hoses at a local hydraulic/truck shop? Aside from the fact that I think its pretty crappy for... Read more
By KN4SYO
Hello everyone, we just bought our first Audi on Friday, a 2018 Q5 with 70k miles. I'm looking forward to learning from all of you. Best, Jerry
By gcthree
Is your insulation missing? Somehow, I ended up with 2 of them and only one C3. Retails around $48 + shipping. Yours for $30 shipped. Let me know. Bob Image:
By bkg
picked up a 97 recently for a build. Phase 1 is just cleaning things up to make it driveable... Phase 2 is 2UZ swap (already have the engine and swap parts).... So dumb random questions to follow.... Slide out cupholder question... Tabs are broken, of course, so i picked up a replacement on the interwebs. The slide out itself is about 1mm wider than factory, so it will not fit in the factory receiver. NBD, I figured, as the new one came with the receiver/mount.... But... how the heck... Read more
By Mr. Breeze
Hi all, I've always thought my '69 Charger felt better at highway speeds than on backroads, but today I've identified the sensation which gave me that impression. It seems my steering doesn't self center nearly as well at low speeds as it does at high speeds. I'm assuming that might indicate an alignment issue with caster? I did new upper control arms, lower ball joints, tie rod ends, strut rod bushings and the CPP disc brake conversion before having it aligned by a local shop about a year... Read more
By tschanne
My new to me 25 GLE450e sits a bit higher than I like so I'm considering lowering springs. Specifically the H&R units. I don't have the air ride so that's not an issue. Is there anything I need to be...
By PeterE1255
Hello I am actively looking to buy a 2018-2020 SL I understand that the SL550 is more expensive than the 450 I do NOT care about HP or top speed/acceleration. Both of these cars are faster...
By PZR
When driving my 67 L-68 Tri power an issue recently has started, when the car gets hot the car dies coming to a stop, but starts right up. I am using 110 Octane racing fuel. What can be the issue?
By 2022FordSuperduty
Hey Guy's ! Ive got a weird question related to I Phone calling connectivity to my 24 that maybe someone can explain or help resolve. I have the XLT premium package with the Bose system. So my...
By Drew745T
Hello Members, I am trying to trace an issue that started before my Fuel ECU 563 went bad, My Fuel ECU 563 went dead, I replaced it with a 967 then found out my running rich issue is still present ! Here's some info and details to help anyone who could have an idea and would like to give me some tips ; I have an AEM Wideband that read 14.7 after startup then go down to 10 after couple seconds of running ! The idle is good until I start to drive the car (put load on it) example I drive... Read more
By Stefanogt3
Hi, I’m looking to buy a used Cargraphic complete exhaust system that was previously fitted to a 996 GT3 MK2 (product code: CARP96GT3RET). Would it fit my MK1? Also, do you happen to know if this...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
