Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Bluebelliedjet
I have recently been hunting a popping sound with no success. I had replaced the tie rods, front shocks, shock tower bushings, ball joints, and the driver side CV joint. Initially I did not detect...
By MarkM
Hi everyone, A couple of months ago I bought a 96 80 series. It sat for a few months Before I bought it, and I am slowly addressing some of the issues and base lining for reliability. I will be building the truck for camping and fishing excursions, as well as a winter 4x4. Today I drained and refilled the coolant with Toyota red. I drained from the lower hose, and filled with water to circulate once the engine came up to temperature. I left the cap off, and waiting for the thermostat to... Read more
By highspeeddirt
When i bought my car, the PO just put a new fuel tank and sending unit in the car. This is it. The inside is spotless as you can see from the 1st Pic. Not sure about the sending unit because my gauge was inop. I went with an EFI tank because I will be running a sniper2. $25 plus shipping from Butte, MT
By jalterman15
I was trying to find a thread that would help me narrow down the problem but had no luck. I got my 2021 rs5 Sportback in June and during the test drive got the coolant temp too high warning and it...
By Roadhunter
I have an annoying engine vibration in my 408 stroker and am looking for suggestions. This has an internally balanced Scat forged rotating assembly which was installed by the builder(not me) and was sent out again to a different shop and rebalanced. The notes he made was that it still had the vibration "can I live with it?". I asked him about it and if i should try a new fluid balance and he said everything was balanced together. It is annoying to be driving at cruising speed and get that... Read more
By GreggyG
What’s the chirping noise here? Not the ticking, I think that’s the injectors. The chirping is there at idle but goes away when the rpm’s increase. It’s at the back of the engine, not the front. ...
By TT-S4
Hi everyone. I have had my 2018 S4 since new. S4 has 62K miles now, and have decided to keep my S4 for the foreseeable future. I am keeping my S4, because it has been a very reliable, quiet and...
By Thunderkiss1965
I have the rear sump pans on, and the motor mounts mostly sorted. Looking for insight re trans crossmember, power steering crossover, where the heck can I put my master cylinder, for brakes. Image:
By azguy
I actually like the update. It has some great ideas and improvements, and some bad ideas too. But it's got more bugs than an Ant Farm and it would be nice to hear from Lucid that they are working on improvements and fixes. So far we are in the cone of silence.
By armenh7
Hey all, I'm looking to move into my first Porsche soon. My car ownership has evolved around BMWs but I feel it's time for a step up in the handling department. I have plenty of experience with BMW...
By dmh_sr
Looking for a red exterior and red interior 67 Coupe (will consider 65 or 66 coupe) Can be NOM replacement engine and 4 speed or 5 speed Prefer complete driver quality car, but can be complete less...
By walleyejack
https://www.corvetteforum.com/forums/canadian-events/2830969-corvettes-for-sale-canadian-section-58.html post # 1157
By Drifting
The endless W-007 pads have been hard to find. However, I did receive a set today from Speedfreaks. They do have some more in stock.
By Ramasaurus
Hi all. This seems to be a question that pops up here about once a year. Typically not a lot of responses to this issue but here's hoping.... Three years ago I had fuel problems ...truck struggled to start and I diagnosed my TIPM as the problem (built in fuel relay was bad). I bought a new TIPM and that solved things. A few months ago the same symptoms showed up - struggles to start. It is still intermittent but becoming more frequent. It could be the fuel pump this time but I suspect... Read more
By bunka
We recently signed for a new RX350h that should arrive sometime in November. We are considering handing down my wife's current 2014 ES300h starfire pearl white with gray leather interior. ...
By El_Dude
Truck needs an oil change again. I've always used the normal "smaller" filter listed for the 5.7. A while back I read on here about using the larger filter that also fits. I tried a larger Fram once, but obviously those are hard to find now. Last year I found the Royal Purple RP20-820 through this forum and bought one from Amazon. Now I can't seem to find that one either. What other brands/model numbers are the same size as the RP20-820? Also, when searching AutoZone, O'Reilly's... Read more
By residualboulders
I've always been into LCs. My oldest bro is into Rovers. He grew up around cruisers too, but since living in Scotland for a couple of years he's caught the Rover bug. One day he calls to invite me on a road trip with him up to Seattle to get a new chassis he's imported for a D90. I'd been looking for a clean 80 for a few years, patiently waiting for the right one - 93-97 with cloth seats, low miles and no fake wood. Triple locked if possible. My dad had one like that new back when I was a... Read more
By Gshill
Has anyone done the high idle mod on a.26 6.7. I only ever done.with a kit in the past.i wanted to do it with a resister this go around.i want to be sure I'm reading the body builders...
By Dauminator63
When my 350 L48 gets up to temp, a thin, white smoke emits from the driver’s side header, cylinder #7. I recently acquired this 1977 project car, and it runs and drives but it’s essentially been...
By Slip_Angle
Hey all, Noticed this while changing wheels today. This is the front passenger side. It kinda looks like a leak that is staining but when I zoom in it seems more like this is some sort of factory...
By dkwasherexd
Searching for a old school microtech dash for the lt10s or ltx16s non CAN. if you have one for sale lmk!
By benc
Hey guys! Wanted to let the forum know of our new Xtreme clearance bumpers for the lc80. These will likely be a limited time offering as we do not expect them to be huge sellers but figured we would put the word out here if anyone is interested. These were designed to be as high, tight and light as possible for the toughest of trails and we recently put them to the test on one of the toughest trails in the usa! Fordyce trail is no joke and we hardly even touched the rear and the front... Read more
By Gshill
Hello from PA. I currently have 4 ford trucks. 26,10,17,65. I've been a ford owner all my life. All my trucks get used towing horse trailers ,flat beds with equipment. And dump trailers. except the...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
