Sign in
Discover

News, forums and creators

Every item links back to where it was published. Follow the sources you trust to build your own front page.

Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.

Latest threads

Filters
NewestFollowing · sign in
EnglishAll languages
Any time24h7d14d30d60d90d
All publishersCorvetteForumRennlistIH8MUDFord Truck EnthusiastsFor B Bodies OnlyFor A Bodies OnlyMBWorldClubLexusRamForumAudiWorldJaguar ForumsLucid OwnersCivicXClassicBroncosTurbobricksSVTPerformanceGenesis OwnersMazdas247RX7ClubHonda-TechNorth American MotoringInsideEVs ForumEvolutionMMy350ZFT86ClubRenntech
All makesPorscheRamLexusFordSEATAudiLucidToyotaDodgeGenesisMazdaHondaPlymouthMINIJaguarVolvoMercedes-BenzBMWChryslerChevroletTeslaJeepHyundaismart
  • IH8MUD

    Anyone tap into DOME light for rock lights in 2017 LC?

    By atsparkinson

    Looking to do a rock light setup similar to those seen in @Eric Sarjeant builds. He sent me several install photos which was very helpful!! Has anyone done this DIY w/o the help of Master Technicians at toyota... looking for the ELI5 explanation on how to do it. Eric did inform me that i would have to use a digital relay but i dont even really know where to begin!

    More Open thread at source
  • Rennlist

    Shortshifter 964 C4

    By Hendrik_FRA

    Good morning, I want to install a shortshifter for my 964 C4. I am mainly driving an hilly roads and less tracks. Any recommendations for a the right parts and brands I should consider?

    More Open thread at source
  • IH8MUD

    HDJ100 ABS unit

    By Yves1970

    Hi, I'm told that these eventually fail. However, these units cannot be had from Toyota anymore. So what the consensus to do here? Get aftermarket parts? If so, which ones or does the entire unit fail?

    More Open thread at source
  • RamForum

    throttle body

    By Orange_Ram

    earlier this week i experienced a drop in rpms after i parked my truck getting home from work. 30 seconds after i parked my rpms dropped from 600 to 500 then down to 300 then back up to 600. all in a matter of seconds. since it was time got replace my battery i figured it could be that. with that being said, i was thinking of cleaning my throttle body. im also replacing the throttle body gasket and getting a new air intake temp sensor. since im dealing with the throttle body already i... Read more

    More Open thread at source
  • IH8MUD

    80 Series Registry

    By FZJ80ismybaby

    I was pondering the idea of having something for the 80 series guys, and hijacking the idea from the 100's and 60's about a registery or picture album in the sticky section. So...here goes, hopefully we'll get it moved to the sticky. 1. Year and model 2. Name of owner 3. Name of rig 4. Mileage 5. Mods...if any 6. How the truck is used 7. Photo. again...small to save space Yeah... if you look in the 60 registery, there is nothing really different between the two, but might as... Read more

    More Open thread at source
  • For B Bodies Only

    1972 Dodge Coronet 4-door Left Rear Quarter Molding Extension (Driver Side)

    By Andrzej

    Hi everyone, I am looking for a very specific piece for a 1972 Dodge Coronet 4-door Sedan/Wagon. I need the Left Rear (Driver Side) Quarter Panel Side Molding Extension – this is the small, curved die-cast chrome/stainless piece with the black vinyl insert that sits right at the rear corner before the bumper. Part number should be around 3579229 or similar from the 1972 Mopar B-body 4-door parts bin. Condition: Needs to be straight, minor pitting or scratches on the insert are fine... Read more

    More Open thread at source
  • IH8MUD

    LX570 lower dash switch panel?

    By 2014 LEX 570 GA

    Does anyone make something similar to the SDHQ panel ( '08-21 200 Series Land Cruiser SDHQ Built Switch Pros OEM Replacement Keypad Mount - https://sdhqoffroad.com/products/08-21-200-series-toyota-land-cruiser-sdhq-built-switch-pros-oem-replacement-keypad-mount ) for the LX570 that replaces the little cubby with space for accessory switches (brake controller, etc.)?

    More Open thread at source
  • MBWorld

    crankshaft oil seal

    By Damiennik

    Hi All I need help asap, I installed a new crankshaft front oil seal, and I think that it went too deep the depth all around is about 3mm past the timing face, can I still proceed with the...

    More Open thread at source
  • IH8MUD

    The Junkyard 100

    By cruiserinsanity

    Several months ago @Godwin and I made a visit to a local junkyard after I found two 1977 2wd Toyota pickups from marketplace. I had been looking for a disc brake truck for a guy for a while to convert his from front drums to factory discs. When we arrived at the junkyard we saw this '99 100 sitting on its rotors at the entrance. I paid the man for the two mini trucks, and we asked about the 100. He had it for several years and had intended to drive it but it kept randomly not... Read more

    More Open thread at source
  • For A Bodies Only

    1967 Barracuda Project

    By Jimpurple

    Project Car 1967 Barracuda notchback Commando V8 273ci 4bbl auto trans $8900.00 or best offer No trades I have over 10K invested in it. This was going to be my retirement project but I can no longer finish it. It is an original Commando car. Frame numbers match and fender tag matches. It runs and I have driven it around my property. I have not done any work to the engine. Great project car as a lot of the major body work has been done. Both rear quarters, both rockers, and cowl... Read more

    More Open thread at source
  • For B Bodies Only

    Instrument panel

    By suprmn2254

    Has anyone installed a aftermarket wiring kit like painless wiring? I need assistance wiring the instrument panel. I don't have the original harness or connectors. Any assistance or pics of how you did it would be helpful.

    More Open thread at source
  • RamForum

    How To: Add Factory Keyless Enter N Go

    By Jimmy07

    Here’s a write up on how to add factory keyless enter n go (push button start) for anyone that wants to do this. My goal was to do this without a dealer visit and entirely with the alfaOBD software, but initially it wasn’t capable of programming the new fob and RF Hub replace. After some back and forth with Alexey (the developer), some debug logs, and a few updates, we finally got it to work. The good thing about adding this feature is, if you’re on a budget, and can’t buy all the parts at... Read more

    More Open thread at source
  • Rennlist

    Blank Canvas

    By midnight

    I've just converted an old farm shed into a lined garage for my 997. Ply lining, concrete flooring just gone in, fixed the leaky roof. Just need to bird-proof it some more. Curious about others'...

    More Open thread at source

Forums & communities

110 listed, 26 connected and bringing in items.

Browse all forums

Suggest a source

Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.

Sign in to suggest a source