P060B code on 2027 Grand Sport
By Burbowl
My new GS threw the above code with service transmission plus engine light at 700 km! Transmission did go into limp mode at one point but came back and it’s now back to the original dealer. my...
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Burbowl
My new GS threw the above code with service transmission plus engine light at 700 km! Transmission did go into limp mode at one point but came back and it’s now back to the original dealer. my...
By Speed Junkie
I picked up these patches from marketplace today. They appear to all be vintage. Was wondering if any of you guys had any info on them thanks.

By SteveJewels
Better grab this one fast. I have no affiliation with this.
By chargervert
The top three Mopars I regret selling are my 69 1/2 A12 Superbee ,my 71 Barracuda convertible,and my 70 V code 4 speed super track pack Road Runner. What is your top three?
By Miami_Lucid_Man
I recently had to replace my garage door motor. I went from an older model chain drive Liftmaster with MyQ to a brand new belt driven model, also with MyQ. I had zero issues setting up Homelink on the old model on my 2025 Air but, this time around, it will not recognize the car (or the car will not recognize it?) during setup. I am following the setup instructions to the "T", just as I did last time (car just outside the garage etc.). It's a late model Liftmaster so I'm 99% sure it has... Read more

By sabres32
Hi everyone, I’m looking for some troubleshooting guidance on a persistent hot idle issue that I’ve been chasing for the last 6 to 8 months. *Vehicle Backstory:* • Car: 1987 928 S4 Automatic,...

By Floridasky
Crossing the block at the Mecum auction next weekend in Fort Worth is an Earnhardt C8 Image:
By Speedbird
I have not installed this yet. Let me know if I have any of the contacts wrong or other feedback. I'll go ahead and post it because I see some people are asking about relays. (Don't exist apparently) It uses the same Bosch relays that "we" use for the headlight power supply mod to eliminate the amp meter feed. (I'm doing that as well) I THINK I may have found a cost effective limit switch that will work from a major manufacture. I'll post back if I find that limit switch will work. It... Read more

By Ski02
Good evening everyone, having a slight misfire on my EX. No check engine light set, I’ll attach a few FORScan screen shots. It says 0 for all the cylinders but the total misfire counter keeps...

By GBeaupre
_*NOS GM 3780118 parking brake cable pulley*_ I have two NOS GM 3780118 parking brake cable pulleys that mount via a bracket attached to the firewall. This pulley is correct for 1964-1966....
By ykf7b0
If you were to pick the best 3 guitarist who ever picked up the guitar, who would these 3 be? I’ll start; 1. Eddie Van Halen. 2. Roy Clark. 3. Ted Nugent

By Dolomite Titan
I custom ordered my 6.8L F-250 SCSB in 2023 and took delivery in spring 2024. It's my daily driver, my family's off-road and overland rig, and occasionally a real truck for hauling and towing. I...
By GreyFC1
I have had cyl 2,3 misfire for about a year now. Chasing spark plugs and gaps, no oil fouling of course a little gassy as the trim is saying it’s rich, vacuum and boost leaks. recently got new coil packs, now only misfire on cyl 3, my next steps would to preform a leak down test/ compression test? new plugs, new boots, data logs don’t indicate crazy fluctuations in the manifold. Could it be bad rings? Possibly a burn valve?? I fear
By Lucid-dream
I’m interested in adding a small 10 inch subwoofer and draw signal from rear speakers (locations?) and place sub in the trunk lower sunken space, draw power from battery. That’s it. No plans to mess with anything else. Is this a foolish undertaking? Anyone with direct experience please any pro tips and tricks greatly appreciated.
By Xarxes
First time writing in a forum like this so we'll see how this goes. I got an '86 Econoline 350 Motorhome with a carbureted 460 that's got an aftermarket electric fuel pump along the rail that I...

By JLT360DENTSIDE
I have been dailying my 76 F-150 for the ladt year and a half. Today on my way to work i noticed a faint smell of burning oil (not to uncommon on this truck due to the high mileage FE) I parked it,...
By moparsquid
Hi lm installing Dr.diff green bearing axels how can I take the thrust buttons out of the third member without taking the third member apart
By DADM0D
I am looking to switch out my PRL Bar and Plate intercooler for a tube and fin. My FK8 has turned into more of a track use and backroads car, with occasional street driving. What are you using to keep those charge temps down, and make your cool down laps effecient.

By NV MY C5
Looking to sell my C5 FRC Car has been in my family over 20 years OZ Racing wheels Borla cat back Harness bar 59k miles otherwise stock, only issue it looses Freon, needs top off once a year....

By ModInJapan
Hello everyone, this is Mod in Japan. We are adding a brake pad set for Lexus GS350 owners to our in-stock list today. Image: ...
By jkstew1
Why did you purchase a stingray vs the grandsport or vice versa? For 90K I can get a 2027 Stingray 2LT Z51 with magride and black wheels for the same price as a 1LT gransdport with no options other...
By Philly3384
I want to replace the wheel bearing and hub assembly on 2012 a6 front passenger side. What does everyone recommend where to buy parts at ?

By patrickdotryan
I know people hate the gas cap tether because it's a weak point, or it swings across the fender. That aside, I went to replace mine, so I ordered the part from Pelican (997-044-200-05-OEM). Good...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.