News, forums and creators

Latest threads

• For A Bodies Only·1 month ago

  Done for the year?

  By gregsdart

  I run an all aluminum 549 cu in bb with 572-13 385cnc heads. I decided to do compression checks and check lash before going to the all mopar event at Rockfalls raceway sept 26/27. I found one cylinder at 245, two at 230, a couple more around 220 and one at 198. So i am guessing i have hurt rings or valves. Will do a leakdown on the one that came in at 198. I sprayed that hole with fogging oul to see if it changed. It only gained 2 lbs pressure . That was cylinder #5. #6 intake rocker was... Read more

  More Open thread at source

  Save
• Honda-Tech·1 month ago

  Ef manual pedal assembly

  By Civic850

  I would like to buy a EF manual pedal assembly

  More Open thread at source

  Save
• RamForum·1 month ago

  2008 Ram 1500 5.7 Hemi Deactivation Cylinder #7

  By KHIll14304

  Had a check engine light about 3 weeks ago and I used the BlueDriver ODB2 to diagnose it. Turned out deactivation solonoid #6 had failed so I replaced it and that problem has not returned. Then a few days later, deactivation solonoid #7 showed failure, so I replaced it and the last 2 solonoids along with a new mds harness because I did not want to dig into the manifold again. Cleared the check engine light. Drove it for about 2 days and once again #7 is showing an issue. BlueDrover does not... Read more

  More Open thread at source

  Save
• SVTPerformance·1 month ago

  Modified FPDM

  By weems

  On the hunt for one before I send mine in to have modified.

  More Open thread at source

  Save
• RamForum·1 month ago

  Misfire in cylinder 1, 4, 7 and random

  By burn1326

  I'm going to try and be direct here, but this has stumped so many. I have a 2011 1500 V8 5.7L Outdoorsman. The truck had about 135k when a misfire in cylinder 1 was detected. I replaced all plugs with iridium autolites. Misfire continued, and I diagnosed a lifter failure in cylinder 1 causing damage to the cam shaft. I replaced the Cam, all lifters, all MDS solenoids, vvt solenoid, phaser, one coil pack on cylinder 1, cam position sensor, the throttle body for the position sensor, and the... Read more

  More Open thread at source

  Save
• IH8MUD·1 month ago

  B-series engine breather

  By gian

  Hi everyone. Can anyone tell me why my engine—which was completely rebuilt 16,000 km ago—is leaving an oil spot on the floor right under the breather hose? Does anyone else have this problem? tank you

  More Open thread at source

  Save
• For B Bodies Only·1 month ago

  No more Kanter 10% member discount ? Well then read this ....

  By paulie-rt

  Hey all. It's been a while since I've been on but I wanted to share this with everyone. After much thought back and forth I decided to order the 1.03" Kanter (PST) torsion bar set for my '68 Coronet convertible build. They are $399 just for the set which isn't too bad. Shipping is included in the price. Anyway I was hoping to use the 10% discount for being a member but read that it isn't available anymore. But my inherited 'cheapness' got the better of me and I searched for any discount... Read more

  More Open thread at source

  Save
• CivicX·1 month ago

  1.5T PRL Intercooler, CAI, Ktuner V2

  By vnp

  $500 Intercooler + Charge pipes $150 CAI $400 Ktuner $1000 all three

  More Open thread at source

  Save
• 

  For B Bodies Only·1 month ago

  70 am Radio

  By 6pktgo

  Here's a 70 am radio with the knobs, I got in a lot & I don't have any use for it , $140 US + Shipping

  More Open thread at source

  Save
• CorvetteForum·1 month ago

  Bad EBCM GM Part#: 22782245

  By TikTok

  I’m getting service alerts for Brake Worn on my 2016 Z06. Dealership after running tests said the EBCM is bad but they are unable to get the part. They said GM has discontinued making the part, Has...

  More Open thread at source

  Save
• SVTPerformance·1 month ago

  FOUND ONE: Cobra Coupe | Premium $ For Elite Car

  By EasyCompany

  I am actively searching for a clean, well-maintained 2003 or 2004 SVT Cobra coupe. I am a serious, private enthusiast buyer with a strong budget. I am ready for a high-quality example and for a seamless transaction. What I Am Looking For: Condition: Clean title, accident-free, with a verifiable history. Paint, interior, and undercarriage must be in excellent shape. Mileage: Sub 20k miles. Modifications: Acceptable. But no high HP builds... Read more

  More Open thread at source

  Save
• For B Bodies Only·1 month ago

  4speed with transmission cooler in the radiator. is this correct

  By Iucgroup

  I have a 68 Charger H code engine 4 speed I’m looking for an original radiator. I thought I found one but it has the trans cooler for an automatic. The seller told me that all 68’s have the transmission cooler. Seam’s strange

  More Open thread at source

  Save
• Ford Truck Enthusiasts·1 month ago

  Alternator voltage jumping around

  By adrianpglover

  This happens more in the morning, especially when driving with the headlights on. It goes away after running at higher rpms for a while on the freeway. My commute is about 12 minutes of 30 mph and...

  More Open thread at source

  Save
• For B Bodies Only·1 month ago

  Florida Man Kidnaps Facebook Marketplace Buyer

  By GTXDAN

  Everything on the internet is true and safe, especially fakebook. A Florida buyer who had already completed one iPhone deal through Facebook Marketplace returned for another purchase. This time, Doral police describe a gun pointed at him, a struggle inside a car and an escape that did not end the threats. The buyer approached a white BMW occupied by two men. In a television interview, Doral Police Chief Matthew Castillo described a rear-seat passenger pointing a firearm at the buyer... Read more

  More Open thread at source

  Save
• CorvetteForum·1 month ago

  Thinking of coming back to Corvette

  By LehmanZ06

  Longtime ex C5Z06 owner that used to autocros. Thunking of getting a C8 Grandsport and wondering if a Z52 package is worthwhile ? How much different are the shocks ? Probably no one can answer...

  More Open thread at source

  Save
• IH8MUD·1 month ago

  Hard thud / clunk during kickdown from 4th to 3rd gear in 2003 LC

  By Pilotsride

  I'm experiencing a very unique "clunk" and can't seem to find previous examples of it in the forums. As the title states, the clunk or kick is typically felt around 30 mph when the vehicle is already shifted into 4th and coasting / steady throttle application. When I increase the throttle enough to force a kickdown to 3rd gear there is a thud or clunk felt just before the RPMs increase as transmission shifts gears. What I've done so far - I have greased all zerks along the front and rear... Read more

  More Open thread at source

  Save
• SVTPerformance·1 month ago

  97-98 Lincoln Mark viii coolant fan

  By 65wildstang

  Looking to upgrade my coolant fan. Looking to purchase a 97-98 mark viii coolant fan. If anyone has one they’re wanting to sell, please message me some pics. Thank you

  More Open thread at source

  Save
• Genesis Owners·1 month ago

  What did you pay for your new Genesis G90?

  By Administrator

  So! What did you pay for your new Genesis G90? This is the spot where you can let others know what you paid - either out the door or otherwise...

  More Open thread at source

  Save
• For A Bodies Only·1 month ago

  Transmissions

  By 91dowdge

  My 1991 w250 came with a np435 and im frustrated with how clunky and slow the shifts are. Its got a 360 mild built stock bottom end but still makes enough power for the transmission to be the limiting factor. Any suggestions for a transmission to buy. Id prefer to swap to a transmission that can bolt to a Tcase.

  More Open thread at source

  Save
• AudiWorld·1 month ago

  Audi RS6 Avant — Production Numbers

  By VWAGfanboy7

  Hi All, Does anyone have actual production figures for the C8 RS6 Avant (2021–present)? I'm curious how many were built worldwide versus how many made it to the U.S., ideally broken down by model...

  More Open thread at source

  Save
• AudiWorld·1 month ago

  Humming noise

  By Clare.g

  Hi all need a little guidance, some times when I start the car there is a whining/humming noise coming from the front right driver (uk) side which can only be heard from the Inside. The noise does...

  More Open thread at source

  Save
• 

  For B Bodies Only·1 month ago

  Original Max Wedge 3447 Carburetors

  By btomasko

  Quantity of 2 for $1500 Make an Offer Branchburg NJ

  More Open thread at source

  Save
• AudiWorld·1 month ago

  Rear brakes

  By Lacucina_chef

  Good morning, y'all! what are folks paying for rear brake pads these days? I recently changed my front one. Yesterday I got the friendly reminder of you need brakes!

  More Open thread at source

  Save
• For B Bodies Only·1 month ago

  Kanter auto discount code?

  By RJ Squirrel

  Getting ready to order some PST 1.03 torsion bars, anybody have a discount code for Kanter?

  More Open thread at source

  Save