Questions on headlights
By pahanorlando
Just took out my headlight today to replace parking light bulb and noticed more issues. The bulb actually appeared to be good and wires somewhat melted. Which means that when I have more money, I'll...
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By pahanorlando
Just took out my headlight today to replace parking light bulb and noticed more issues. The bulb actually appeared to be good and wires somewhat melted. Which means that when I have more money, I'll...
By 68-4JRB
Lens only, no housing Used with a few crow feet fractures $25 plus shipping from Rapid City SD 57702 I can take additional pics if helpful I have PayPal I *think* these are same for 70-74 Challenger but buyer responsibility to confirm
By oneye85
So I am trying to get all my ducks in a row for an engine swap and most likely a rear end swap as well. So the question is I see everyone using the explorer rear ends for the 8.8 swap and it makes sense but is there a reason for not using a mustang rear end besides more cutting of brackets. Is the offset wrong/not wide enough/ some other issue I’m not thinking of. I do not have an issue with getting one but I have access to a nice mustang unit and was wondering. Thank you.

By tallyankee
Hello, I just pulled my instrument pod and ran into a few issues while reinstalling it, so I like to ask the group to help me out. The right side of the pod's securing bolt went in fine, but...
By liege
According to the CTEK manual (page 11), “some Lithium-ion batteries have an on-board UVP protection that disconnects a dischard battery. This prohibits the charger from detecting the battery. To...
By Sesselmarder
Hi all, last weekend, I received multiple system failures on my 2024 992.2 Cab S. It turned out that some unwanted rodent visitors who chewed through some wires.... I had my car at the Porsche...
By WhoDey
I'm considering a couple of options for 20/21” winter tires on my Gravity Touring: Lucid-recommended Hankook icept evo3 X winter tires Michelin CrossClimate2 3PMSF all-weather tires Both should meet my winter traction needs. I'd like to hear feedback from anyone who's run either of them on a Gravity: How bad was the efficiency hit vs. the OEM tires? How were the noise levels? Any other significant pros or cons? Thanks!
By Talamant3z
I just keep having unfortunate luck with this damn car and I need some turn around. Hopefully someone here can help. The car will not start/crank (I was told those words are 2 very different things...
By chargervert
I have a 2019 Ram 3500 4x4. The last couple of times it has rained,when I open the hood about a gallon of water comes out of the back corners of the hood. Its like water is getting in between the inner structure and outer skin of the hood and sitting in there unless I open the hood after every rain event and let the water drain out. I figure it is getting in around the emblem bezels on the rear sides of the hood. Anyone else having this issue on their modern Ram trucks. I figure it won't be... Read more
By Winecountry
My 2001 VDP has 44 k miles. I get a clunk in reverse if I on cold start don’t let rpms go below 1,000. I don’t do this often but my question is this common?
By SweetT
Like others, I've rewatched the more popular youtube build series (Throtl's Bad Apple/Sonoco; Smeedia FD, Hunt Co FD) multiple times through. I'm looking for other entertaining/informational youtube...
By gtman
Back in October 2019, I came up with an idea. Everybody in the community was getting concerned with a recent spate of tuned cars blowing engines. We had guys blathering "Don't be an idiot, all tuned cars will fail". Frankly, even though I was reliably tuned for a year and a half at that point, I was getting a little worried too.That's when my Tuned CivicX Experience & Reliability thread was born... Five years of blood, sweat and tears
By hemismith
I have a 2025 Hurricane SO with 22k miles. For the past month or so it's been having an occasional rough idle, where it will drop a couple hundred rpm for a second. Occasionally it will drop several hundred, and a few times it's even stalled. I've read on other sources that it's likely due to a non-stock air filter -- when I had my 20k service, there were no Mopar air filters in stock so they used a Napa. But that was months ago and I just started having this issue when they did a PCM... Read more

By heywodja
I have a 78 AMP Alternator part #4091424 up for sale. Works well, I switched to a single wire style. 30.00 Plus the ride.
By ECantu
Hi! I just got a transmission problem in my 2016 Ram 2500 5.7. I was driving on the freeway and after a curve suddenly lost all power, it was like if the transmission was in neutral, no sounds, no leaks, no burning smell or anything, it just went dead. I pulled over and it didn't let me put it in park, screen showed a message "speed too high to move to parking" or something like that. After a few minutes the shifter let me put it in parking and I was able to shut down the engine, even when... Read more
By angrypengu
Just a fun thread as we are perhaps 4 years way from the D6. What are things you want that you can't get from the D5 today? For me, there's just two things. Storage (lol) and an all aluminum...

By ModInJapan
Hi folks, Mod in Japan here. Putting RS-R Down Sus lowering springs for Lexus ES350 owners in front of you, available from us now. Image: ...
By dirtyern98
I just bought a 1953 COE with the M series flathead six. The truck appears to be complete with the exception of the ashtray and voltage regulator. I can do without the ashtray, but I kinda need the...
By ARL_350
This is somewhat of a stupid post and there isn't really a solution to it. My RWD ML just constantly loses the rear end, not from a dig, but even upto speeds around 25-30mph. The car has new Pirelli...
By 03TRCBRA
Brand new Eastwood powder coating gun with some accessories (silicone plugs, hooks for hanging material and containers for material) and two bags of material (mirror black and silver vein) all new was gonna tinker with doing it but never got an oven and it just sat in the garage $100 plus shipping
By Dan Brewer
Below you will find our current inventory of main cases that have a VIN number for those looking. 307 bearing main cases. 0B126864 0B128766 0B131885 0B134786 0B150879 0B189450 0B194382 0B202856 0B219287 0B255005 0B259434 0B283974 0B292699 0B296558 0B298002 0B308617 0B371393 0B374763 0R137160 0R149493 0R176631 0R189038 1B160865 8A125824 8A129236 8A132285 8A136817 8A152337 8A155320 8A172084 8A174379 8A184300 8A195460 8A209962 8A215486 8A216998 8A219994 8A235359 8A244369 8A244680 8A245559... Read more
By supaaacharge98
I am wanting to meet some Honda/Jdm enthusiasts like me who can talk about cars (mostly civics) and build plans, mods, etc. It would be nice if you want to kick it and help each other give advice on builds and to go to meets after covid. I don't have facebook, but if your nearby Fairfax VA and want to talk about your civic let me know.
By Cedar Plank
2021 Classic Express with 3.6L. Newer vehicle to me and just recently removed the air intake cowling. Discovered a hosed fitting that is not connected to anything. See it in the center of the attached photo. Any ideas what it is and if it should be connected anywhere? Is that a plug on the end of the hose? Couldn't see anywhere that it should be connected to.
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.