Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By First_EV
Hello - My Air's warranty is expiring this November. Someone from the Lucid texted me for extending the warranty. Has anyone extended warranty on Air? I have not yet replied yet, but like to find out if anyone went through it. Thanks!
By grnonions
I recently had my 981 into a performance motorsport shop, upgrading the Girodisc rotors on the front and back along with some new pads among other suspension bits, and asked for stainless steel lines...
By The Crusher
I have lower control arms with the factory sway bar tabs. Looking for OEM front sway bar for 67-69 coronet, would like to find w/ frame mounting brackets, drop links etc
By bauto
Just wanted to let you know the car is now live on Bring a trailer, it’s been a great car but time for another project Hopefully someone will post the link thanks Bob Image: Image:
By UmCanesZ06
Front and rear. Brand new, still in the plastic wrapping. These were about $200 when I got them. Im selling for $125 shipped. Image: Image: Image:
By Kylackey
Hey MUD, Long story short. Truck has been gone through tip to tail. Full rebuild, All toyota parts ect ect.. Truck has about 10k on the rebuild, and to my knowledge I have footage of it running on first start up but I can't tell if it has always made the sound. Can you guys let me know if this sound at idle is normal? I dont have anyone local to me or anybody with another 1FZ to even compare this sound to. Sounds like a hollow tin "ish" kinda clatter in the bottom end. Does not transfer to... Read more
By MDHunter
Looking to replace the carpet in my 2000 f 250 crew cab, any recommendations? Mike
By UmCanesZ06
Front and rear AC Delco rotors, still in the plastic wrapping. These were about $500 when I got them. Im selling them for $375. Id prefer a local pickup because shipping will most likely be pretty...
By Michael Hanson
Hi, Anyone know the part no? Toyota has sent it wrong twice? It’s not 88716-60730. Thanks, Mike
By MoneyPit1969
At the recommendation of a fellow forum member I purchased a reman head from Allied cylinder head near Atlanta, Georgia. Does anyone know or have experience with these cylinder heads. Does it come...
By Jeff T.
Found this in a new to us 2016 convertible, it's mounted under the glove box. It has a 3 wire connector going into it. I've been all over the car and I can't seem to find anything. It has a Wind...
By Jerry991
I have a 991.2 GTS with center lock wheels that were painted satin black from the factory. The satin finished always looked dirty to me so I had them powder coated in gloss black and then cleared. ...
By UmCanesZ06
Front and rear. Brand new, still in the plastic wrapping. These were about $200 when I got them. Im selling for $125 shipped. Image: Image: Image:
By LC Family
So I am looking for engine compartment splash guards for my 1972 FJ40 (9/'71 build date) and I am having trouble figuring out which ones to get. It seems the shapes and sizes changed over the years and most sellers do not indicate which year they are for and the info I have found can get contradicted by others. Looked for photos of early 1972 engine compartments but no luck seeing clear pictures of any guards. Can anyone with an early '72 40 confirm which splash guards are the correct... Read more
By Wikedc7
I parked my vette at home after filling it with gas and went out 3 days later to go to a show and I had all dash lights like normal but no crank no start and the check engine light stayed on. I had...
By BluegrassMotorsport
For sale is my 2014 Corvette Z51 w/mag ride in Laguna Blue over Kalahari. It’s a 3LT (no dash bubbling) with nearly every available option and *_manual_* transmission. Currently has around 53,400...
By UmCanesZ06
AC Delco C6 Z51 rotors, still in plastic wrapping. These are a good upgrade for c5 corvettes. You just need to add C6 caliper brackets. These were about $500 when I got them. Im selling them for...
By SageRick
I purchased this from a family friend. The pickup has low milage and the best of care during its life. It sat for 20 years when I bought it. I’ve put 6,000 miles on it, and did a lot of maintenance...
By PoorHouse
Got back into a Land Cruiser this weekend. This may be a familiar vehicle to some on here. Seller is a member and long time TLCA member. It's been 10 years since I sold the last one, this is the 4th. I had an '84 FJ60 for 5 years in the late 90's to early 2000's, a very brief stint in an '88 FJ62, then a '97 FZJ80 from 2010 to 2016. Loved all of them. The right combination of size, capability, practicality and reliability. The '97 was my favorite, blending classic Land Cruiser... Read more
By Jace Yates
I have a stock 302 roller bloc out of a 1990 Crown Vic. Plan on machining it and boring .020 over. .550/.540 in. Lift cam with 62cc assembled heads and stock pushrods, 1.6 rockers. Everything else...
By cryorunner
After I finally got a test drive in the GX550 OT+, I’m left unimpressed, and was hoping to get some feedback from other 80 Series owners about their feelings of the GX as a valid replacement for my aging LX450. Mud seemed like the best place to try, with lots of 80 owners, and LC enthusiasts adding the GX to their collections of older models. After the test drive I’m left really torn about the GX, and now more panicked because I’ve already gotten a couple of calls from dealers with random... Read more
By ProjectApollo52
So i have a 2013 lexus LX570, its got over 190k miles and ive owned it since it had 0 miles on it, recently the AHC pump went out so i replaced the pump, the shocks and struts, and the globes all at the same time all are oem toyota/lexus parts, ive made sure to bleed the system at all four corners AND the 5th accumulator and i can confirm there is no air left in the system, the car will go to the high position, normal and low position with no problems, HOWEVER only the front end seems to be... Read more
By ModInJapan
Hi everyone, Mod in Japan here. We wanted to share a WALD carbon fiber trunk spoiler for IS250 / IS350 owners that we currently have on our shelf. Image: ...
By ZINN928R
Hello all, Over the past 3 months I have become intimately familiar with a number of clutch threads and have followed the advice or procedures outlined in many of them...and I am no closer to...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
