Paint protection film
By Midnightmadman29
Has anyone peeled off the clear PPF down by the lower quarter in front of the rear tire ? I have a tiny line of dirt trapped behind mine. Does anyone my a pre cut replacement?
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Midnightmadman29
Has anyone peeled off the clear PPF down by the lower quarter in front of the rear tire ? I have a tiny line of dirt trapped behind mine. Does anyone my a pre cut replacement?
By TJFA22
Hi everyone, looking for some diagnostic advice on an intermittent cutout issue with my ‘87 944. The car sat in storage for roughly ten years with minimal use before some minor recommissioning a few...
By KohrtRacing
Was shopping for a new housing and center section and happened to stumble across this Thought I’d make sure everybody was aware that Moser has an overstock sale on their rear end and axle packages for 9 inch housings. A, B and E-body. Some strong stuff on a great discount. They apparently bought a supplier out and have several months worth of inventory... Read more

By walltoride
Recently purchased a 997.2 and the natural brown leather steering wheel has these dark marks along the top of it. Anyone have any experience with removing them? Car has been garaged since new so...
By khoney
Driving a 2025 CX-70 Turbo Premium Plus (MHEV version). In all of the online literature I have read, Mazda's i-Stop engages under certain conditions but only when the vehicle is at a complete stop. I hate i-Stop, and often disable it, but I often still forget to do it until the first time it kicks in. For over a year now, I have only seen it engage when at a complete stop. For the last week, it has been engaging at all different vehicle speeds, every time I let my foot off the gas. The green... Read more
By thom_87XJSC
Been reading Greg In France's excellent distributor service writeup. One question - is vertical movement of the star wheel/rotor to be expected? Mine has a noticeable amount of vertical play,...
By First_EV
Hello - My Air's warranty is expiring this November. Someone from the Lucid texted me for extending the warranty. Has anyone extended warranty on Air? I have not yet replied yet, but like to find out if anyone went through it. Thanks!

By grnonions
I recently had my 981 into a performance motorsport shop, upgrading the Girodisc rotors on the front and back along with some new pads among other suspension bits, and asked for stainless steel lines...
By The Crusher
I have lower control arms with the factory sway bar tabs. Looking for OEM front sway bar for 67-69 coronet, would like to find w/ frame mounting brackets, drop links etc

By bauto
Just wanted to let you know the car is now live on Bring a trailer, it’s been a great car but time for another project Hopefully someone will post the link thanks Bob Image: Image:

By UmCanesZ06
Front and rear. Brand new, still in the plastic wrapping. These were about $200 when I got them. Im selling for $125 shipped. Image: Image: Image:
By Kylackey
Hey MUD, Long story short. Truck has been gone through tip to tail. Full rebuild, All toyota parts ect ect.. Truck has about 10k on the rebuild, and to my knowledge I have footage of it running on first start up but I can't tell if it has always made the sound. Can you guys let me know if this sound at idle is normal? I dont have anyone local to me or anybody with another 1FZ to even compare this sound to. Sounds like a hollow tin "ish" kinda clatter in the bottom end. Does not transfer to... Read more
By MDHunter
Looking to replace the carpet in my 2000 f 250 crew cab, any recommendations? Mike

By UmCanesZ06
Front and rear AC Delco rotors, still in the plastic wrapping. These were about $500 when I got them. Im selling them for $375. Id prefer a local pickup because shipping will most likely be pretty...
By Michael Hanson
Hi, Anyone know the part no? Toyota has sent it wrong twice? It’s not 88716-60730. Thanks, Mike
By MoneyPit1969
At the recommendation of a fellow forum member I purchased a reman head from Allied cylinder head near Atlanta, Georgia. Does anyone know or have experience with these cylinder heads. Does it come...

By Jeff T.
Found this in a new to us 2016 convertible, it's mounted under the glove box. It has a 3 wire connector going into it. I've been all over the car and I can't seem to find anything. It has a Wind...
By Jerry991
I have a 991.2 GTS with center lock wheels that were painted satin black from the factory. The satin finished always looked dirty to me so I had them powder coated in gloss black and then cleared. ...

By UmCanesZ06
Front and rear. Brand new, still in the plastic wrapping. These were about $200 when I got them. Im selling for $125 shipped. Image: Image: Image:
By LC Family
So I am looking for engine compartment splash guards for my 1972 FJ40 (9/'71 build date) and I am having trouble figuring out which ones to get. It seems the shapes and sizes changed over the years and most sellers do not indicate which year they are for and the info I have found can get contradicted by others. Looked for photos of early 1972 engine compartments but no luck seeing clear pictures of any guards. Can anyone with an early '72 40 confirm which splash guards are the correct... Read more
By Wikedc7
I parked my vette at home after filling it with gas and went out 3 days later to go to a show and I had all dash lights like normal but no crank no start and the check engine light stayed on. I had...

By BluegrassMotorsport
For sale is my 2014 Corvette Z51 w/mag ride in Laguna Blue over Kalahari. It’s a 3LT (no dash bubbling) with nearly every available option and *_manual_* transmission. Currently has around 53,400...

By UmCanesZ06
AC Delco C6 Z51 rotors, still in plastic wrapping. These are a good upgrade for c5 corvettes. You just need to add C6 caliper brackets. These were about $500 when I got them. Im selling them for...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.