Sign in
Discover

News, forums and creators

Every item links back to where it was published. Follow the sources you trust to build your own front page.

Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.

Latest threads

Filters
NewestFollowing · sign in
EnglishAll languages
Any time24h7d14d30d60d90d
All publishersCorvetteForumRennlistIH8MUDFord Truck EnthusiastsFor B Bodies OnlyFor A Bodies OnlyMBWorldClubLexusRamForumAudiWorldJaguar ForumsLucid OwnersCivicXTurbobricksClassicBroncosSVTPerformanceGenesis OwnersMazdas247RX7ClubHonda-TechNorth American MotoringInsideEVs ForumEvolutionMMy350ZFT86ClubRenntech
All makesPorscheRamLexusSEATFordAudiLucidToyotaDodgeGenesisHondaMazdaPlymouthMINIJaguarVolvoMercedes-BenzBMWChryslerChevroletTeslaJeepHyundaismart
  • RamForum

    p0172 running rich, max fuel trim

    By 98RAM59

    98 RAM 5.9 I have been chasing a running rich condition for months now, I do not know what else to do at this point. P0172 code, no other codes currently. Occasionally it throws a transmission range code of some sort, but I doubt it has anything to do with the running rich. Fuel trim is a -33.6% which I believe is the max Rebuilt engine New Delphi fuel pump assembly (50-55 psi prime/running, drops to 30ish psi after sitting for 30 minutes) New plugs, cap, rotor, cam and crank sensors... Read more

    More Open thread at source
  • RamForum

    P082 Fix - recommend scanner?

    By Georgiagru

    I just picked up a 2002 Ram 1500 and rebuilt the transmission, plus new pinion sensor. My Ediag Elite scanner is giving me a P082 code / number of tone ring teeth out of range /Tire revs per mile out of range. I know I need to reset the pinion factor. Took it to the dealer today and they got a VIN Mismatch error between the PCM and the ABS Unit, and told me they could not work on anything older than 2007 with their current system. At least they did not charge me. So, I am looking for an... Read more

    More Open thread at source
  • RamForum

    2026 RAM 2500 – Cab lights lifting while driving?

    By Slaghdog

    Has anyone else run into issues with the cab lights on a 2026 RAM 2500 coming loose while driving? I started noticing wind noise and discovered that three of the front cab lights had lifted/come loose. I removed and reinstalled them, but they came loose again after highway speeds. It looks like the front hook on the light isn’t large enough to hold it down properly in the front. Is this a common problem? Anyone found a good fix? Any help would be appreciated. 2026 RAM 2500... Read more

    More Open thread at source
  • RamForum

    2005 ram 4.7 random loss of power, pulling 7° timing, no clue why. Please help

    By krankmotorsports

    Hello yall. I got a real problem child ive never seen before. I drive the same way to work every day. I can 100% feel the power loss. Its the difference in climbing a hill at 50mph at 25% throttle, then next time it takes 80% throttle to get up same hill barely getting to 50mph. Watching data, appears that something is ringing the knock sensors, causing ecu to pull up to 7.5° timing......which kills power and fuel milage. Had a lifter chatter at startup, replaced all lifters... Read more

    More Open thread at source
  • RamForum

    Lawsuit for Bubbling Dashboard - Filing

    By davidw172

    Hi everyone! I am filing suit against Ram for the bubbling dashboard on 1500 Limiteds. Any other Floridians out there want to join me in it? Please get back in touch. I plan to file at the end of November to give some time for us to get together at least 100 people with the same issue who have had to pay out of pocket for the repair. My attorney has an interesting angle I won't divulge.....

    More Open thread at source
  • RamForum

    GM tranny question

    By Dan Topp

    Is there a trans heater or thermo bypass available for the 24- 9T65 9 speed in my caddy I want the same results as the ram for towing as this is normal towing in cool temps not like Tx where we are going in February . Thanks.

    More Open thread at source
  • RamForum

    UBL 8.4" Uconnect 5 kit with built-in nav — wireless CarPlay for 2019–2024 Ram 1500

    By DDoffroad.com

    Still on the 5" radio, or an older 8.4" that needs a cord for CarPlay and has no real nav? Our UBL 8.4" Uconnect 5 kit is the factory OEM route for 2019–2024 Ram 1500 (DT). - Genuine OEM Uconnect 5 UBL 8.4" (not an Android head unit) - Built-in GPS navigation - Wireless Apple CarPlay / Android Auto - HD Radio + SiriusXM 360L ready (subscription required) - Plug and play, pre-programmed to your VIN; keeps your steering wheel audio controls - Panel, bezel, harness, gateway bypass, GPS... Read more

    More Open thread at source
  • RamForum

    Shifting Hard after hitting speed bump on 99 ram

    By PoorManRam1999

    My 1999 dodge ram 1500 5.2L magnum with NV3500 is at 144K miles and NV3500 has been shifting fine ever since purchasing last year. Took my wife to the dentist and went over a speed bump pretty hard and truck started having difficulty going into first and second gear and relative difficulty going into the others including reverse. Thought it was a Hydraulics issue so replaced the clutch slave & master cylinder with a new assembly. Better. Then today I... Read more

    More Open thread at source
  • Genesis Owners

    G70 Garage Sale !! Half the Price !!

    By jayjayralph

    Trading her in and everything gotta go JB4 = sold Bov = sold pedal tuner = sold intakes = sold exhaust = sold Intercooler = sold BMS JB4 Tuner , ewg wires, ikh27 plugs, BMS plug gapping tool, BMS Plug Scocket, Bluetooth $350(268USD) + Shipping BMS petal tuner SOLD Tail BOV and BMS y pipe $220(168USD) + Shipping AEM Intakes $220 (168USD) + Shipping Velossa tech ram intakes $120 CDN (92USD) + Shipping... Read more

    More Open thread at source
  • RamForum

    Title: Need Title: Need help locating engine ground straps – 2009 Ram 1500 4.7L with 2012 engine

    By jjts

    Hi guys, I’m trying to track down some electrical issues on my 2009 Ram 1500 4.7L. The truck has a 2012 4.7L engine installed, but it is still using the 2009 engine harness. Right now I’m trying to physically locate all of the engine/block/head ground straps. So far I found: One ground near the oil dipstick area Two grounds on the lower driver side/front-middle area On the passenger side rear of the engine, I found two braided ground straps coming from the same area One of those goes to the... Read more

    More Open thread at source
  • RamForum

    Junsun JS-CA-XTRAM72C troubles

    By G_Max

    I replaced my OE radio in my 2017 Ram 1500 to a Junsun JS-CA-XTRAM72C and I am having trouble trying to get the backup camera to work. I put an aftermarket Tail gate handle camera on tied into the reverse wire and ground wire on the 7 pin trailer connector ran the video cable up to the front and attached to video for the camera on the head and the reverse trigger wire on the head unit. Put truck into reverse just get a camera icon with an exclamation mark. Can't find my truck in the list of... Read more

    More Open thread at source
  • RamForum

    Gen 4 vs Gen 5 Quad Cab rear seat

    By 670hoth

    I currently have a 2017 Gen 4 quad cab and am looking at new Gen 6 Rams and would prefer a quad cab for the longer bead as I have now. Does anyone know if Ram has found a way to squeak out a tiny bit more comfort in the rear seat of the Gen 6. Or the other possibility that they lost a little bit. The Gen 4 rear is adequate for kids and smaller adults and even average size adults for rides up to an hour or so. Of course, longer rides than that in the rear is not that comfy. Any experience... Read more

    More Open thread at source
  • RamForum

    Help!

    By alandrio

    2025 Ram 1500 Laramie.. So after my first winter with this "brand new" truck, this began to happen around the rear wheel flares.. I went to the dealer immediately.. I keep my truck spotless.. wash it by hand, winter use touchless wash only(high powered sprayers)..and even put a nice coat of wax prior to winter.. The dealer ended up telling me that they've never seen it before.. sent a claim in and it was denied.. blamed it on road conditions, winter weather, etc... This past winter was 2nd... Read more

    More Open thread at source
  • RamForum

    Preparing for winter

    By horzepower

    I've had my 2022 ram 2500 bighorn long bed for 3 years and it is absolutely terrible in any amount of snow or on dirt roads that are not maintained. With winter approaching I am trying to decide if I just need to add weight to the bed or if I should get new/better tires. It currently has Cooper Discoverer AT3 XLT (LT275/70R18) that the dealership had put on. The tires probably have around 30k on them. In snow it fish tails, will swing out to the side when turning and downhill the ABS will... Read more

    More Open thread at source
  • RamForum

    2016 RAM 1500 Laramie discontinued part BUYOUT ?

    By TommyEL

    Can I get help… what is a BUYOUT ? I have a 2016 RAM 1500 Laramie 5.7L gas with a discontinued part. My truck is dead with no communication and I’m getting no help from dealer because they say they don’t want to work on my truck. I had it towed there because that’s what stellatlantis said to do. Now the dealer said they’re offering a $2500 buyout ??? What do I do with a dead truck?

    More Open thread at source
  • RamForum

    "Upgrading" from '22 to '02, Will I Regret It?

    By SirDave

    I'm thinking about replacing my '22 RAM Cummins with a '02 Dodge Cummins. I really like the quiet, comfortable ride of my '22 but every time I hook up the trailer for a trip I worry that it is going to leave me stranded someplace in the middle of no where with an emissions issue. I used to have a '98 Dodge Cummins - I loved it and put well over 100k almost trouble-free miles on it but the body was disintegrating so I got a '14 RAM Cummins. After about a year I had to replace a NOx sensor... Read more

    More Open thread at source
  • RamForum

    Replacement fan and Mabye block and pistons/rods

    By Madoc colt

    I’m wanting to replace my fan on my 2013 ram 1500 5.7 and I want the electric swap to clear room in the engine bay I’m wondering which to get and where to get it I have a cam torque converter 6.4 intake manifold and need a new block and forged pistons now that I blew a whole in my block if you guys have recommendations on that too

    More Open thread at source
  • RamForum

    Service 4wd

    By ramguy2025

    I have a 2025 RAM 2500 Cummins with just over 11K miles on it. A couple days ago I went through the carwash with under carriage wash and after driving a few miles and coming to a stop it was making a growling noise coming from under the truck, the SERV 4WD light came on and it wouldn't shift into 4wd. I did a soft reset on the Uconnect and that did away with the SERV 4WD light but it was still making that noise. I drove it around in my yard and put it in and out of 4wd and everything is... Read more

    More Open thread at source

Forums & communities

110 listed, 26 connected and bringing in items.

Browse all forums

Suggest a source

Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.

Sign in to suggest a source