Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By WhysoJoe
*2016 991.1 GT3 RS - finger follower and camshaft replacement, engine out* *The car* 2016 GT3 RS (991.1), Lava Orange, PDK, PCCB. 47,XXX miles. *Why* The 991.1 GT3 and GT3 RS share the...
By Jcjbadger
Hi All- New to the forum. Great source of info. Saying hello and here is my new to me 991.2 Turbo. I am enjoying every drive :) Thanks for the welcome! Image:
By 01Defense
Went to the track yesterday and ran a modded GTR and a GSX Cpe. Went I got to the track, the DA was about 2000. My first race was against the GTR. Driver said it had 900hp. My Eray HTC has CAI,...
By AZ69SBPOST
I recently got scammed on this radiator and should have been more cautious. It happened to me on the roadrunner forum and the member was banned by the administrator. So I am back on the search for this radiator and it can be needing a rebuild, no problem. Thanks for your reply’s, I wish to get back to having positive vibes again. Thanks members, Nick
By blu63sky
Does anyone have a simple way to remove the pass side turn signal bulb for replacement on the C6 with the tire/wheel in place? To be specific just locating the ‘socket removal tab’ I have seen the...
By Poser
If you have an original 2F in your 40 or 55 , please post up your engine serial number, and the month/year of your truck build and the vin if you would. I am trying to complie 2F year data. I will be posting this up in the 60 section as well. Thank you for your help! -Steve
By C4 Steck
I just wanted to post this because after 30+ years, I’m sure others are having the same issue. I was having an idle fluctuation, surge, and stalling issue especially when the car was in gear...
By Ox1500Sport
For those that have had the Recall 03D/NHTSA 26V-059 for the Trailer Tow Module - better yet, if there's a Ram Tech in this group - what work was done other than replacing the module on the rear cab wall? Specifically, is programming also needed? I'm getting a bit of the run-around because my 2025 didn't come factory with the integrated brake controller (in the dash), but I added it later via the P/N 82219232AA kit - that kit included a new Trailer Tow Module that replaced the original... Read more
By KWLC250
Is pinstriping in Citrus or Ocala inevitable? I've got a new truck that doesn't have PPF or paint protection. Looking to hit some trails in the area and hopefully avoid destroying the paint. Any trail recommendations/feedback appreciated. Thanks!
By jvojvo
I currently have Michelin PS4s, but will need new tires fairly soon. Does anyone have any thoughts or experience with the 5s? called Tire Rack, and they were no help at all. thx!
By freshspecbluegt
Hi all, I have been chasing an intermittent stumble and occasional stall for some time now. neither the stumble nor the stall trigger a CEL, and the truck will start right back up and run like normal. Occurs exclusively at just off idle, when starting off from a light or stop sign. I have worked through lots of different diagnoses and replaced a number of parts: Harness is in good shape, no burns, rewrapped zip-tied away from EGR Replaced fuel pump with new sock New TPS IAC passes... Read more
By Riley
Hi all, I have a 2019 G70 with 34000 miles on the odometer. The car has suspension creaking and the dealer is saying it needs lateral arms replaced and 2 shocks! Unbelievable! How can a car with so few miles be so deteriorated? I have a Honda Odyssey with 200K and the suspension is still OK. Anyway, anyone else have these problems and have you been able to get any sort of Genesis help to resolve the issue?
By lhhnick
Hi everyone, I have a 2017 Audi Q7 Prestige 3.0T supercharged V6 (EA837) with approximately 150,000 miles. I'm planning to perform this maintenance myself in my home garage and would appreciate...
By 76redvet
There seems to be a mixed and somewhat confusing bag of LED headlights available for C2s (Holley, Octane Lighting, Headlight Experts, etc.). Most advertise a Low Beam and a High Beam headlight or say...
By KOSTIC
Well, its been a fun 3+ years with my '23 RS5 Competition, but I have to admit that I am no longer in the RS5 club. I've been having an itch for about a year now and finally scratched it. I traded...
By Chiclassics
I know this is Bronco specific forum, but wanted to share this as these are California all original horses and potential brothers of other broncos. Couldn't pass up on these for $8k, got'em so fast like I stole it. 67 (Green) California car - full options except AC , 68(Blue) - full options - including AC. Will be doing a stock resto taking care of some rust repairs then getting the engines started. They were told to be sitting for 5 years. ... Read more
By Ernie02
Hi I'm a new member. In the middle of a front end refresh. I've done new tie rods and sway bar. Starting on new bearings for front axle. I bought the 4 tooth socket but on disassembly found no nut!...
By Cmackr56
Howdy all. Bought a 20216 Ram 1500 Limited in July. I'm 70 years old and first time Ram owner. Coming out of a GMC Denali 4wd, already have 6000 miles in this vehicle and it's probably the favorite vehicle I've ever owned. Truck is Serrano Green, 4wd Hemi with 3.92 gears. Only thing I 'm not loving is the fuel economy, best tank (hand calculated) was 18.2. Seems to average about 17.5. I realize one doesn't buy a truck like this for fuel economy but compared to my Denali and previous two F150... Read more
By jmarkey77
[img alt="Crossed the threshold on my '14 Z51 last weekend. I put over 80k of the miles myself. Still puts a smile on my face every time I get behind the wheel!...
By pjazz
Selling my 15 GT3 I've had the car for 5 years Title is free and clear. Car has been tracked a few times a year, but maintained regularly. No accidents. I have all service records including...
By fallenangel96734
I have a crack in my 991.1 cup windshield, anyone had to change theirs? Who did you go through? What was involved? any info would be appreciated...
By vetsvette2002
On a 1967 L79 and a 3810 Holley, what is the correct mounting gasket? Should my FLAPS stock it ? Thanks in advance
By senecagreen
Has anyone removed the helmsholz resonator between the airbox and intake tube (where the emissions stuff plugs in) and replaced it with a strsight tube and flexible coupling on each end? I am...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
