Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Touge.ca
*October 12th Thanksgiving Long weekend Monday 9am - 5pm Mosport DDT Lapping event, #18 Touge.ca event 2026!* 2022 event Photos & Videos (http://www.touge.ca/-2022-track-photos) / 2023 event...
By highspeeddirt
I have 2 sets. Both have pitting, but one set is in decent shape. Number 1 is the worst pitting, and number 2 is pretty decent. All the pins are in tact. I do not have the nuts. $60 OBO for #2 and $30 OBO for #1. Buyer pays shipping from Butte, MT
By bgiere
I have a new VBOX Racelogic CAN Gateway module seen below for sale. It is brand new and never used. $400 plus shipping. Email me at: jd2640@aol.com ...
By mtgadbois
I have a recent buy - 1987 911 Targa (OUCH). My current problem is that I am trying to find parts for a stock fully electric Recaro seat. I have a grinding noise when moving the seat backwards. Cause...
By Gknow
Does anyone have any tips/tricks to get more range from the idler pulley? I can't get it to move enough to get the belt back on, as it stops rotating and the nut starts to turn. I've already...
By motown
A very close friend of mine, Mike, is finally treating himself to a long-awaited TTS after years of hard work. I shared this site with him and suggested that he or I can post his spec here, as...
By Wheelytech
What hinges do you use. Is the lift off style jeep hinges? Do you just pop the pin in and out on the normal hinges. I have a 74 FST the currently has no doors but has hard door hinges. I plan to have full and half hard doors. Want to make the best choice for swap ability. Also I can’t believe how heavy these old doors are. I will be using bug catcher style doors.
By angrypengu
As we all know there are press embargos so no one actually can get any reviews on this car until it launches in Q4. I owned my Range Rover for a little under 6 months and while I don't regret it...
By KFC1
I'm planning to buy a 2009 CR-V EX-L, 2WD, 5-speed automatic, with about 265,000 miles. It has the original K24Z1 and original transmission. It's been well maintained but uses about a quart of oil...
By KeiranKiller
Installed 27won CAI race MAF and 27won TIP and my car has been running rich with ltft going as high as -25% generally sitting at -21% it’s triggering code p0172. The car sits at a much higher stft when idle going up to -25% but when under throttle slowly corrects it maintaining speed light throttle sits at the -18% but when actually getting on the pedal it gets much closer to 0% The code turns on and off as my ltft goes below roughly 20% but generally the error code and lights are all... Running rich -23% LTFT
By CloneTommy
Currently rebuilding a cylinder head for a 1994 Honda Accord EX. Looking for an OEM set of Valves and Rocker Arms.* If you only have a few of them, not the whole set, LMK.* I am still interested if...
By bb66cuda
I have this intake manifold which I believe is a Lynx that currently has 3 1.5 SU carbs on it. I’m trying to figure out if that was what was originally was supposed to be bolted onto it. Has a homemade aluminum plate since the bolt holes don’t line up on the carbs. Any input would be appreciated.
By vinniemacroger
hey guys - apparently I need to shout out that I'm here, looks like a great place I stumbled too. Looking to join the gxor with a future (hopefully immediate) purchase of a Canadian 2009 GX470. There's a question though, this one in particular has a buzzing noise when I shift the 4WD between N - H and N - L. The truck is in neutral, brakes pressed, and makes a buzzing noise and returns to normal after in gear. Any thoughts?
By drsfmd
Brake lights work. When the headlights are on, the dimmer part of the bulb lights. The turn signal in front works. I don't think it can be the hazard switch, as I have a hyperflash harness...
By Reginald
Hi it's Reg. I have a 72 Valiant that needs help. Car has been stored in a heated garage for over 25 years covered in a tarp. It does not start. Good tires put on so it can be towed to a garage. I am not much of a car enthusiast so don't know what is wrong. Boosting won't help. I will need a garage that is close to Ballinafad Ontario that is reputable to work on it. Must be someone who knows this type of old car well. Can anyone point me in the right direction? Ballinafad is just west of... Read more
By 3point29eight6
The car is a 2000 Boxster S with 16K miles. It's all original down to the Pirelli P zero's it came from the factory. It was last registered in 2008. As far as I know it haven't ran since about 2010....
By JR02Z06
Currently running ARH with catless x pipe to stock exhaust. Looking for TI, Corsa, possibly Billy boat. Looking for someone local to the NJ or Tri State area. Anyone?
By junior340
1999 JC Penny 2 car set. Never been out of package Cool stuff to add to your collection. A couple scuffs on top picture should show if you zoom in but real nice overall. $50 shipped USA or work it out elsewhere
By Jet_R
Howdy all, I’ve got a 1989 Ford F150 Supercab XLT Lariat 5.8L C6 4X4 that I’ve owned for 9 years. The truck has been, as Fords usually are, a great and dependable vehicle, often times acting as...
By QQ1Dart
I had posted this earlier to the Welcome Wagon Forum as well. Hi all, long time listener, first time caller. I have a 1967 Dart 270 that's my first Mopar. I have a question regarding the rear of the frame rail on the passenger side. The frame rails are in great shape except for this one small section in the rear where trunk rot got to it, and I have a frame rail section to replace the rotted section. How do I section the rail while the car is on the ground or jacked up? Do I section it... Read more
By DWS44
Had a nice long cruise in the new GS this afternoon, and I still can't get over how much *better* the exhaust note and volume is with the LS6 & Center Exhaust on this thing compared to the...
By Franken470
Registration is live!! October 8-11 Southern Cruiser Crawl Registration - Register for Cottonland Cruisers' annual Southern Cruiser Crawl at Hot Springs Off-Road Park. Your registration includes admission to the event and one event cottonlandcruisers.com
By jgcable
I am about to begin the tear down on my 74. I currently own the FSM for my old 77. Considering they are both small block 4spd cars would the 77 be good enough?
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
