Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Clapdgs430
I read somewhere that a gs300 differential has shorter gearing than the gs430 differential, so ive been thinking for a couple days would it be possible to swap in a diff from a gs300 into my 430, do...
By JG71B
Ill leave this here. If not allowed please delete.
By Green2000LX
On a 98 I recently got (rust belt) I started getting this worn gritty bearing sound that’s fairly consistent. (Can be heard with window down under 10 mph) Truck has 216,000 all dust shields look pretty crusty especially the alternator. I’m planning on replacing the alternator, belt, idler and tensioner pulley. I’m gonna get a reading on the alternator when the truck is running later and recharge the A/C on the whim that it might be low on refrigerant? Probably not but worth a shot. Any... Read more
By bluehatch17
Fits Sport/sport touring only. Only up to 2019 model year. 2020 has the center diffuser already from Honda. Hatchback ONLY, CENTER section only. $250 shipped or cheaper local. local highly preferred. Brand new not even removed from wrap. HIGHLIGHTED yellow CENTER section only.
By alanroberts50
Local indie JLR specialist very kindly squeezed me in just before the holidays last year to have the knock sensors and wiring loom replaced. Seems they were rushing to get me the car back as they...
By flagstaff
I just picked up an '48 FJ60. 2F engine with a 4 speed manual. Very excited. I've had a few 80s, a 100, and a 200 but never a 60. I have a couple questions. I haven't had much luck with the search and was hope a few of you fine folk might chime in with some advice. 1. I'm not sure what kind of headlights these are. I have noticed that when a blinker is used, a ring on the headlight lights up with the blinker. (I also think the blinker is fast so perhaps the added LED is... Read more
By Midlife rider
My first vette had it about a week. It’s an automatic with 4k miles. Been reading through a bunch of threads. 1. Concerning fluids- I wasn’t able to get much service history so guessing I should...
By jjt446
For Sale: 1970 B-body Rally Dash radio bezel for AM/FM radio. Was restored as a back up to my AM radio. Perfect condition; restored original OEM radio plate. Asking Price $150
With the engine off and cool, I pulled the A8 automatic transmission fill plug out and fluid immediately began running out. I probably lost half quart before I got it back in. I expected the fill...
By vicsnothome
New guy but long time lurker. Can't find the information I need so finally signed up. 76 f150 4x4 with 360. I know the engine mounts are side specific. I know this is the right side mount but not...
By Jallen8289
ABS Module saga 2015 1500 My abs module went out and had code C2200 on my alfaobd. I searched for a replacement for a month and found one from a guy parting his truck out. It had 200,000 miles so I figured it was a crap shoot. Checked the codes on his truck first and didn't find any. Bought his for $200 and installed it that night. Worked fine for 5 days but then got in the truck this morning and its now giving the same code. Could something be causing this or am I just that unlucky that... Read more
By RDL005
Anyone have what they call an extended crank? 2022 Ram Power Wagon 6.4L . It doesn’t happen every time you try to start it. And it will start every time. But occasionally it is a super long crank. Dealership gad it for 5 weeks. Finally said it was fixed after replacing the fuel pump and fuel pump relay. Went to pick it up. Did the very same thing on my first crank.
By Chi Town Runner
Here's something I put together to assist in decoding 1968 ONLY - VIN info and FENDER TAG information. Is it 100% correct? Nothing is 100% especially when it comes to Mopars. I've done my best to make it as accurate as I can. If you find an error other than an opinion let me know. Maybe the Mods may find this good enough for a sticky. The PDF file is 4 pages. Frank Edited for Frank by Mod on 9 June 2021.
By Wrong_Crew_4557
On my 1971 144S The fuse for the instrument panel lights keeps blowing. I’ve gone through to ensure there are no loose connections or corrosion. Clusters still work without the fuse. Just the illumination lights do not work. Everything seems to be clean. I’ve also tried Ohm’ing it out but there seems to be no issues between the fuse panel and the final wire at the back of the panel. The connector in the last photo is what is providing power to the illumination panel. It lasted two days and... Read more
By LisaG
Would like to buy a GM OEM transparent roof panel with hardware for C7 - would need it shipped if too far away from Texas
By mtbiker
Gents, I recently did a brake job on my brother's 2001 2WD F-150. All went as planned until it was time to bleed the brakes. My brother was working the paddles and I was opening the bleed screw as...
By SteveSS
Your Tums and Pepto Bismol is CaCo3. Calcium carbonate. That's limestone. It counteracts the acids in your stomach. Yep, my Master's degree is geology. Your silicon spray coating is SiO2. Silicon dioxide, on your paint job. That's quartz.
By 70dusterA62
First of all I have been working on this car for a while now so now it will turn over fine but no fire or run but possible fuse bulk head maybe culprit and some possible key switch faulty ? Notice it too easy turn no sound so you know normal click sound like original chrysler sound . 1. Installed protronix kit Orange wire go to positive and other 2 wires one black and blue from harness go to negative correct ? So far lights work yes, turn signal works yes and what else do I need to look ... Read more
By A body
Not sure why... but I really had the motivation to work on the car yesterday. Mocked up the mounts and spacers, drilled and got the threaded inserts in place. Got the engine sitting in a correct enough position to where most of the header tubes align. Made an appointment with a local header guru to finish them up. I tried playing around with my welder on a few sections of header tubing, but I don't have a bottle and really couldn't get a good quality weld with the rosin core wire I have. I'm... Read more
By S2daosn
Hi I'm currently in the market for a spyder rs and I would really like a car with buckets, mags, ccbs and weissach but i recently found a car that checks all my boxes but doesn't have buckets Im...
By daddydeluxe
Just got this 2000 996 C4 Cabriolet with 72,000 in Chicago and drove to LA on Route 66 (100 year anniversary this year). Highlight (was actually the lowlight) - hit a giant raccoon night one,...
By smartobject
I have the trans almost separated from the block. But it seems less like something is resistant to change. Just under the spot for the starter. All bolts are out and converter bolts out also. ...
By hotrod1442
I have a 2013 FR-S that has been tripping P000A, and P0016 codes, after replacing all the cam phasers (did them all to be on the safe side), timing chains/tensioners, oil control valves, and cam position sensors, I'm still getting the P000A. P0016 codes. After doing some research on this it...
By NYC Bronco
I'm installing mine tomorrow and I realize ti comes with no instructions, which isn't a big deal for the cage but I could use some guidance for all the assembly pieces for the seat belts. Any one have a PDF or other format copy? They provided a QR code to download instructions but the link is broken so no luck there.
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
