Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By fabieber
I was about to throw it away but decided to see if anyone might want the original Parchment White upholstery for the rear seat. There are no tears and no stains. I will offer them FREE OF CHARGE to anyone who may live close enough to pick them up and for the cost of shipping to distant locations.
By AudiLover13
Hi everyone, I couldn't find any existing threads covering this topic, so I'm opening a new one regarding the replacement of lower spring perches on an Audi A4 B6. On my current shocks...
By StanfieldNC
Looking for the driver side seat back cover only for a 1969 Dodge Dart Swinger 340 with the split-back front bench (D2X black vinyl bench seat). My driver side back has a tear near the bottom. The passenger side and the bottom cushion are fine, so I'd rather not buy a full set if I can avoid it. Open to: Good used original NOS A single leftover reproduction cover from someone who bought a set and only needed one side Condition: no tears or splits, seams intact. Some light wear is fine... Read more
By Crider
Pulled the rear seat out of my 68 project yesterday was happy to find the intact broadcast sheet still in the springs. Pulled it out as careful as I could be and got it out intact, only to find that it was to another car. Does anyone here have 68 Road runner post car with VIN. RM21H8G240719? If so I i have your paper.
By A12005
I am selling my 1969 Plymouth Road Runner true X9 paint with broadcast sheet. Non original 383 with a converted from automatic to 4 speed. New engine rebuild and new Brewer four speed transmission. New M&H wiring harnesses throughout the car. New exhaust with original chrome tips, bumpers, clean and straight grille,tail light bezels and bumpers. Bucket seat car with no console or buddy seat originally. Car was an original non vinyl top car with black hood stripe treatment and the wide white... Read more
By eagleflyer
I got this kit for my truck(when I bought it was in the seat, never installed) but fail to see the use. Do these just replace the standard rear view camera? And if only on when in reverse then would...
By 66/440
I want (need) to refurbish the bucket seat tracks for my '64 Fury. I have seen several threads on the later model tracks but nothing for earlier seats. Has anyone done this? I need to understand how to separate the tracks so I can inspect / blast / paint and lube. All help appreciated as usual pictures are the gold standard! Thanks
By Case45
I'm looking for someone that wants to swap their 4th Gen Ram pickup full console for my partial console/ jump seat assembly from a 2015 Ram 2500 Laramie. My console/jump seat is black and in excellent condition. This swap requires swapping the radio bezel and lower dash trim pieces as well. Your console MUST be: - In good/great condition - Black in Color, both the body and the lid. - include all mounting brackets, HVAC ducting, and trim pieces. - be from a 2013-2018 Ram Your radio bezel... Read more
By Flint
My bench seat is rusted badly and have searched for a long time for one with no luck. Considering the procar low back and maybe getting it upholstered in the decor light and dark green like original if possible. Has someone fit them to a 69 B body and if so what was needed? Do any of the adapter bases they have reasonably work? I called legendary about covering them and was rudely told no. I imagine they get their materials from some where so !
By AsherDad
* Selling my 2026 Porsche 911 Carrera T, finished in GT Silver Metallic over a Black interior with leather seat centers. * *The car currently has approximately 2,200 miles and is a two-owner car.*...
By Carbonzhp
My lease car is developing small tears on the outside driver seat bolster. Recommendations for (preferably mobile) repair?
By msapers
Does anyone have pictures from back in the day? To get started, this is me in front of my Dad's '75. Picture was taken in August of 1977. The 'cruiser had burbank springs, 32 inch Tru-Tracs on White spokers, Downey header, Holley carb and a Warn winch. My Dad used to take me on club runs in a car seat! I'd love to find this rig again. Hopefully it's aged better than I have!
By Matt993992
1989 Porsche 911 race car with the following: wide-body conversion, 3.6 liter 993 engine (built in 2020), Ohlins shocks, Brembo brakes, Recaro seat, fire-suppression system, fuel cell, 3 sets of...
By Terese
I removed the rear seat on my 2003 RX300 a while back (Long enough that it's all foggy to me now!). I can't remember how to attach the two 12mm bolts to the metal brackets under the seat. Should I...
By Blutz3
OLD discontinued parts. I was told to ask 1200 for these by a reputable parts seller. 950 Location 47025
By da Vinci Dan
2009 C4S Coupe, 6MT, 55K miles Passenger seat is currently Laaaaaayed Baaaaack... With its mind on its money and its money on its mind. Thank you Snoop. Anyway, I went into hot functions on my...
By Vets-Vet
I am interested to hear your story of replacing seat material. I have repaired mine many times over the years but are getting crispy, stiff, and itchy, the material simply has to go or get covered....
By CatchMoTrout
Hi all, Does anyone know the order the seat belt hardware stacks for the front? I have lock washers, washers, spacers and rubber grommets strewn all over the floor and I can’t seem to correctly recreate the stackup. I should have taken a picture of the order originally. I know I know. Any help would be greatly appreciated. Thx!
By Double Porsch'n
Really enjoying the seat swap/addition threads. :corn: Hoping to fit more of my kids in the GT3. Maybe even make it a 5-seater...well, 5-ish :eek:
By Dennis Keane
I just bought a Genesis J 90, 2023 and I’m disappointed in the comfort of the driver seat. It feels like I’m sitting on a bench. How do you make it feel very cushy?
By Cummins242
Hello guys I’m new on here but thought some of you guys might be able to point me in the right direction. I have a 2012 3500 tradesman with manual seats and no lumbar. I just bought leather electric sport seats from a 2014 ram 1500. I want to put them in my truck just curious on wiring schematics. The plugs are different. My truck seats have air bags along with the new sport seats. Haven’t started the swap yet just trying to get information. I scored and got front and rear leather seats... Read more
By Joe_buonomo
Hey all, not sure if it’s been posted here before but here’s what’s up: I have a 2016 2500 SLT, came with cloth manual seats, I just upgraded to the Laramie leather seats and need some advice/help with the electrical stuff. The yellow plug under the seat hooked up fine but none of the buttons (to move the seat forward/back tilt etc.) work currently. Because my truck is an SLT, I’m not sure if the wiring is tucked under the carpet or if I need to add all new wiring and buttons and such. Any... Read more
By sleepy
I have a 2016 Ram 2500 Tradesman. I tried to take out the driver seat and put in electric seat. I jumped power to it so it could work. But now the seat belt light is on and my airbag light is on. Anybody out there have a fix for this? Or am I wasting my time?
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.
