News, forums and creators

Latest threads

• CivicX·1 month ago

  Crank Position Sensor Wiring

  By Jason Baker

  So when I blew up the block on my 18 Si, it blasted the starter, the block and also the crank position sensor. It blasted it so hard that it shattered the plugs and snapped the three wire connectors. With the new block, I obviously replaced the sensor. I’m not buying a whole new wire harness! But….. I still need to locate the correct connector. Can anyone help? I’ve been looking for hours and cannot seem to find any wire schematics or diagrams or even what the connector is called. Please let... Crank Position Sensor Wiring

  More Open thread at source

  Save
• Lucid Owners·1 month ago

  Gravity and Grizzl-e Chargers

  By 20/20

  Curious as to the experience others are having using a Grizzl-e Charger (Ultimate 48) to charge a Gravity. When charging at home, the car accepts the hard wired Level 2 charge (40A breaker, charging derated to 32A, car set to 80% max) and when complete, stops charging. It is at this point that the charger displays an ERROR CODE of 'Relay Stuck'. This ERROR will persist until the car is unplugged (or breaker reset) and then the charger will clear the fault in a minute or two of being... Read more

  More Open thread at source

  Save
• AudiWorld·1 month ago

  Full brake set from 2023 Audi SQ7 <20k miles used

  By Audisthesiology

  Hi folks Took this brake set off at around 20k miles with mostly highway driving so would be a shame to keep uselessly in my garage. Front and rear rotors with mated pads and their shims. Throwing...

  More Open thread at source

  Save
• Ford Truck Enthusiasts·1 month ago

  Power steering leak after tightening box

  By bounceroo

  I must have over tightened the steering box but because the shaft is pushed down enough to see shiny metal by the Pitman arm shaft. I loosened it back off. That mistake aside, I have a leak now by...

  More Open thread at source

  Save
• IH8MUD·1 month ago

  WTB: 2016-2021 Lexus GX460, Northeast

  By 2wheeldev

  Looking to buy a privately owned, well-documented 2016 to 2021 GX460. Stock or lightly modded is fine. Black on black preferred but open on color. Under 110k miles. Full service history matters more to me than a low odometer. Coolant valley plate and water pump records are a plus. Based in North, NJ. Will drive anywhere in the Northeast to see the right truck. Serious buyer, ready to move when the right one shows up. DM me.

  More Open thread at source

  Save
• 

  For B Bodies Only·1 month ago

  1969 GTX Air Grabber Vent Emblem Hardware

  By braydun

  Hi, Members. I'm looking for mounting hardware for the 440 emblems that attach to the air grabber hood vents. Mine are currently being held on by tape. I think these were attached at the factory with plastic sleeves (which I have 1 of 4) and nuts (which I have none). I don't see any aftermarket options. Appreciate any suggestions. Thanks

  More Open thread at source

  Save
• 

  Ford Truck Enthusiasts·1 month ago

  Rear Disk Conversion--WITH parking brake!

  By F-250 restorer

  I did the disk conversion a few years back and drove w/o a parking brake for years. I really missed it and was gearing up to do the SuperDuty rear swap to get the p. brake, but started reading a post...

  More Open thread at source

  Save
• SVTPerformance·1 month ago

  B.A.T. Shill bidding scam?

  By IA Shelby

  Saw an article that Bring a Trailer removed a recent Corvette Grand Sport because the company (Marshall Goldman) that listed the car had one of its owners set up an alternate account to drive up the bidding on its own auction. Reports allege (don’t know if this is true) that is a very well known car guy influencer that is an owner of Marshall Goldman and was the one propping up the bids. Anybody know anything more about this?

  More Open thread at source

  Save
• IH8MUD·1 month ago

  OEM Winch Bumper

  By Cruiser804

  Anyone know the story on these? I assume they were only available outside the USA. What years? Can a US 80 be retro-fitted with one. Any sources? I have only seen 2 pictures.

  More Open thread at source

  Save
• 

  For A Bodies Only·1 month ago

  Duster Stolen

  By AbodyBB

  I am searching for my 71 duster that was stolen from my land in Rosamond CA. It was stored in my trailer which I believe was the real target of the theft. If anything shows up that is that green or you think it may be it’s a V8 car with power brakes big bolt conversion on the front and B body 8 3/4 in the rear. Last numbers of the VIN 133362

  More Open thread at source

  Save
• ClubLexus·1 month ago

  2007 Lexus ES 350 Intermittent Complete Power Loss - Looking for Ideas

  By eggo998

  Hello everyone, I'm hoping the collective experience here can help me diagnose an electrical gremlin in my 2007 Lexus ES 350. On multiple occasions, I've experienced a very unusual condition...

  More Open thread at source

  Save
• IH8MUD·1 month ago

  LX470 '06 headlight upgrade! Glass/polycarb and LED or HID

  By packeted

  Hey folks, I'm planning to upgrade my 06 LX headlight situation. I already have the projector brackets from LB Lightwerks but am now planning the rest of it. My lights have seen better dates so I was considering buying a new stock pair (seems that $750 is about the going rate). Any thoughts on glass vs polycarb housing? I'm assuming that the glass ones are the 99-02 and they would fit perfectly in an 06? Also as I plan my projectors, any thoughts on LED vs HID? I have some HIDs in there... Read more

  More Open thread at source

  Save
• RX7Club·1 month ago

  REW inspection covers

  By FDAUTO

  Looking for the rear iron inspection covers. The one on top (which is available new apparently and also from jp3) and the one on the turbo side which seems to be a lot harder to find

  More Open thread at source

  Save
• Lucid Owners·1 month ago

  Wrap Color for Lucid Air Trim

  By JeffZebry

  Hi everyone, I was interested in wrapping the trim pieces on the air and was wondering if anyone knew what the most comparable wrap is to the color lucid uses on the factory option? So far I've found 3M 2080 Satin Black and I think it is pretty close, but I just wanted to see from anyone who's actually done it. Thanks!

  More Open thread at source

  Save
• 

  For B Bodies Only·1 month ago

  1962-65 front frame rails

  By Lee Robinson

  I have a pair of solid front frame rails from a 65 Coronet. PO had removed the upper control arm bumpers to install a rack and pinion set up. They will have to be welded back on the rails. $250.00 each rail plus shipping from El Dorado Hills, Ca. PM me if interested.

  More Open thread at source

  Save
• Ford Truck Enthusiasts·1 month ago

  1979 Ford Truck Service manuals and other Ford Truck manuals

  By Ford-F100

  Ford Truck Service manuals (3), and other Ford Truck manuals (4) for sale. Slightly used, in really good condition. Sell all together, will not sell single manuals. $50 for all 7 manuals, plus...

  More Open thread at source

  Save
• IH8MUD·1 month ago

  Shop wants $475 to replace 2 plastic tees in heater hoses.

  By wadeanderson

  Am I crazy to think that is an outrageous price? They are doing the timing belt and water pump and I asked about those tee connections. They said they use OEM ones and total is $475 to replace the two of them. I can’t understand how the labor could be so high. What am I missing?

  More Open thread at source

  Save
• ClubLexus·1 month ago

  CD-Changer not playing, no error message.

  By AlTruistic

  I have a 2001 LS430 UL with the Mark Levinson system, I have never really messed with the CD-Changer until a few days ago. The player will accept and eject CD's just fine, but will not play them. ...

  More Open thread at source

  Save
• 

  IH8MUD·1 month ago

  Source Thread / Fix - Night Vision Cover, HUD Cover, Bezel, Night View

  By 1994LCNM

  I was wondering if anyone knew where I can find this? Mine was cracked on the bottom so I need a new one though can't seem to locate it: Lexus 86497-60020-E0 Bezel, Night View ​ 2002-2007 Lexus LX470 8649760020E0 Thank you for your time!

  More Open thread at source

  Save
• 

  ClubLexus·1 month ago

  WOLFBOX 7th Anniversary GIVEAWAY! Share Your Road Trip Story & Win Rewards!

  By Wolfbox

  *It's our 7th anniversary, and we're celebrating the best way we know how — by giving back to YOU, the community that makes it all possible.* Over the past year, you’ve hit the road, discovered...

  More Open thread at source

  Save
• 

  Rennlist·1 month ago

  WOLFBOX 7th Anniversary GIVEAWAY! Share Your Road Trip Story & Win Rewards!

  By Wolfbox

  *It's our 7th anniversary, and we're celebrating the best way we know how — by giving back to YOU, the community that makes it all possible.* Over the past year, you’ve hit the road, discovered...

  More Open thread at source

  Save
• 

  Honda-Tech·1 month ago

  WOLFBOX 7th Anniversary GIVEAWAY! Share Your Road Trip Story & Win Rewards!

  By Wolfbox

  *It's our 7th anniversary, and we're celebrating the best way we know how — by giving back to YOU, the community that makes it all possible.* Over the past year, you’ve hit the road, discovered...

  More Open thread at source

  Save
• IH8MUD·1 month ago

  Coppernicus the FJ60 Survivor

  By sadovnik

  No doubt we tend to get pickier as we get older. I suppose the same holds for buying cars — the more you've owned, the more particular you become. I'd been hunting for an FJ60 or HJ61 for the better part of a year. I bid on a few promising rigs on BaT, but nothing panned out. I was somewhat willing to compromise on mechanicals and mileage. Rust, however, was non-negotiable. It had to be essentially rust-free, which is a tall order on a 40-year-old Land Cruiser. After an expensive lesson... Read more

  More Open thread at source

  Save
• 

  Honda-Tech·1 month ago

  WOLFBOX 7th Anniversary GIVEAWAY! Share Your Road Trip Story & Win Rewards!

  By Wolfbox

  *It's our 7th anniversary, and we're celebrating the best way we know how — by giving back to YOU, the community that makes it all possible.* Over the past year, you’ve hit the road, discovered...

  More Open thread at source

  Save