Door Locks
By Pete R
Anybody having issues when you try to lock and unlick the doors with the touching the door handle? Not all the time but more than it should be. Have to use the fob instead.
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
By Pete R
Anybody having issues when you try to lock and unlick the doors with the touching the door handle? Not all the time but more than it should be. Have to use the fob instead.
By orig944
Reposting as a new thread on behalf of k7acz Sorry, not sure how to post this question. I have a 1983 944 (original owner) that the horn has quit working. I searched my owner's manual and Haynes...
By rafter75
Is anyone running the center lock version of the Apex VS-5RS rims on there 997.2 GT3/RS?

By Coelacanth
I just replaced my transmission filter and pan gasket after emptying the transmission fluid. The job was a lot less messy by first pumping out most of the fluid from the dipstick tube with a hand pump; almost no tranny fluid was spilled. That's a good tip for others planning to do the same job. I want to replace the tranny fluid that's in the original torque converter, I've never done that before. Apparently I can remove the inspection cover on my 1970 Charger's 727 bell... Read more

By Romanu29
Hello all, Bought my first Corvette, a C7 Grand Sport, a couple months ago. I'm coming from the Shelby GT350, which I loved, but am now loving the Corvette. Just wanted to say hi and look...
By Case45
I'm looking for someone that wants to swap their 4th Gen Ram pickup full console for my partial console/ jump seat assembly from a 2015 Ram 2500 Laramie. My console/jump seat is black and in excellent condition. This swap requires swapping the radio bezel and lower dash trim pieces as well. Your console MUST be: - In good/great condition - Black in Color, both the body and the lid. - include all mounting brackets, HVAC ducting, and trim pieces. - be from a 2013-2018 Ram Your radio bezel... Read more
By 72Roper
Does anyone have a recommendation for a a vendor or resource that sells a full exhaust system as a kit? I found a couple threads on here that referenced a vendors kit but it had been discontinued when I looked it up (can’t remember the vendor offhand) Any feedback appreciated!
By Valvefloat991
On a 2000-mile trip through the SouthWest last month, I got a brake wear alert on my 2017 Carrera. My car has just under 30K miles and I have taken it to two track days, so this was not unexpected....
By FJAK
Any ideas? Dome lights don’t work in any position, even with any door open. Clock inop as well. Fuse is fine. Bulbs are fine. Relay? Control module? Room Lamp Control Module aka Ignition Key Cylinder Light Relay (85965-60010)? Any other ideas?

By xmaciek82x
While changing my oil the other day, I noticed one of the rubber seals is looking very odd. Red arrow in the below picture. I'm unsure if it was installed incorrectly by someone or if it is...
By Valvefloat991
On a 2000-mile trip through the SouthWest last month, I got a brake wear alert on my 2017 Carrera. My car has just under 30K miles and I have taken it to two track days, so this was not unexpected....
By 73rrrd
I have a 73 roadrunner with a 340 , I decided to put in a mechanical oil pressure gauge, after I got it in I drove it around drove great was showing around 50 psi on initial start up after driving and warming up around 25 - 30 psi just driving around, as I'm about a block from home my pressure gauge was showing 0 , was running great pulled it into the garage and shut it off . so I decided to pull the coil wire take out the oil sending unit from the block to see if oil would shoot out of the... Read more
By t.flatt
After putting this job off for a few years it was time to get it done. And, thank God it is!!! It's a big job to take on and I already know sanding bores the hell out of me! The orange peel wasn't that bad so I started with 1500 grit, then 2000, 2500, 3000 on a DA, then 3M's 3 step process of pads and polishes. I think it came out pretty damn good!
By AWildDugong
Up for sale is my 2017 Aegean Blue Honda Civic Type R, just under 21,000 miles. Clean Carfax, 2nd owner bought with 26 miles on the odometer. Always garaged and stored for the winter. All parts have been professionally installed by Impulse Performance in Minnesota. This car is track and show ready! Will throw in a set of Volk TE37 Saga S-Plus Matte Black 18 x 9.5 +38 wrapped in like new Nankang CRS (2022 compound, <100 miles on them) 265/35/18 for 51k. Performance/Engine - 4 Piston short... (Built Motor, FBO, Hondata Fuel System) 2017 Aegean Blue Honda Civic Type R 40K Minnesota
By nvrstuk
I've got a barely used ring and pinion for a True Hi 9 I used to run. Much less than 15K miles. EXCELLENT condition. Reasonable offer. Dana 20 output shaft is complete... carry a spare if you ever do any kind of wheeling. I'll have more stuff popping up because I was/am sick and tired of my boxes of stuff so it's all being organized so I've finding some old stuff that I removed back in the '70's! lol Interested? PM me as I had to put something on the price list but we can discuss it... Read more
By BlackEvo08
Selling a pte 6870 gen 2 turbo that came off my 05 evo 8. Made a easy 910whp on 46psi and e85. Fairly low miles on the turbo. About 5k miles. Selling for 1000 and buyer pays shipping

By mclarenmaniac
Image: Who: Mclarenmaniac (Insta ID) What: 8th Annual GT Meet 2026 Where: Porsche Tyson’s Corner When: 10/24/2026, 8:30-10:30am
By dremtofford
my truck has a topper and it is getting tired. the struts don't hold it up anymore and it has some cracks in it, and it doesn't lock should i get ride of it or try to fix it.
By Dan400Man
My ES350 has 260k miles on it. I've had it for just about a year and put ~10k miles on it. It's throwing a P0157 and I'm wondering whether it makes sense to pay for a diagnosis to determine that, in...
By deerow
Interested in 944s. I hear the transaxles are underrated, great-handling cars and can be affordable if I am willing to work on it myself. Excited to engage with owners to learn about their stories...
By BaboonFury
Selling the rear bumper with valance from my 08 Turbo in Ruby Red Metallic. It was removed at 41,000 miles when I swapped it for a euro spec one. The valance has some light scuffs that will be easy...
By ogreman72
Hey yall, im currently having a problem with my blower motor. It stopped working out of the blue the other day and I replaced it with another blower motor and its still not working. When I check voltage at the blower im seeing voltage despite either the old blower motor or the new one kicking on. Im thinking it might be the blower motor control, is there a way I can test it before I just buy another one? Coincidentally my driver side window also went out a few days later. Any guidance would... Read more
By 27F350
Anyone here ever participated in the Ford Early Access Program, if so, what was your experience?
By w4tch3r
I bought a used 2009 xf recently and the diff went bad after asking dealer they said they discontinued the whole assembly so i got from used parts a diff after changing the diff the both axle side...
110 listed, 26 connected and bringing in items.
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.