1965 Coronet Convertible Upstate NY
By BrownTeamster
Does anyone know this car ? It’s in Brockport NY. I tried reaching a couple of times no answer.
Discover
News, forums and creators
Every item links back to where it was published. Follow the sources you trust to build your own front page.
Threads shown here are headlines only. Reading and replying happens at the original forum, under its rules.
Latest threads
Filters
All publishersCorvetteForumRennlistIH8MUDFord Truck EnthusiastsFor B Bodies OnlyFor A Bodies OnlyMBWorldClubLexusRamForumAudiWorldJaguar ForumsLucid OwnersCivicXClassicBroncosTurbobricksSVTPerformanceGenesis OwnersMazdas247RX7ClubNorth American MotoringHonda-TechInsideEVs ForumEvolutionMMy350ZFT86ClubRenntech
Bilstein damptronic - wrong kit on car??
By TooTall
Sup? So I got a 991.1 C2S earlier this year. It had a set of bilstein damptronic "coil overs" on it and sits quite low. I recently started prepping the car for a track day (belt, plugs, coils,...
Dropping out engine with 4 post hoist
By qkcuda
Has anyone ever dropped the engine trans combo out of the bottom of the car using a four post hoist? Could you build a cradle and lower it down onto the cradle, then pull the k frame bolts and raise the hoist?
Enablers, good, bad?
By bobj49f2
As a self confessed enabler I was wondering is this a good thing or bad? 🤔 One of the employees of a customer, a person slightly younger than me and never had a vintage truck showed some interest...
5 inch to 12 inch upgrade Alfaobd settings
By Twfish
Hello all, first time poster long time lurker. Getting ready to do the upgrade from a 5 inch to 12 inch and I’m looking for what all settings I need to change with Alfa. Most everything has been from going from 8.4 to 12 but almost nothing about 5 to 12. It looks like for sure I need to change ICS and DCSD but I’ve seen different things for the HVAC. Will I need too change something for dual climate zone or anything else? Thanks in advanced.
FS (For Sale) 1968 to Early 1969 steering coupler / rag joint
By dharris45
This is a freshly restored rag joint for a 1968 or Early 1969. Price including shipping is $300. Thanks, Don Image: Image: Image: Image:
FS (For Sale) Michelin Sport Cup 2R ZP Tires (off ZR1 ZTK)
By serendib
Michelin Sport Cup 2R ZP Tires. DOT 02/2026 and 08/2026. 275/30-20 and 345/25-21 2027 ZR1 was delivered to our home on 9/24 by Intercity Lines enclosed carrier from MacMulkin. Tires were taken off...
1958 Ford F100 complete set of hood emblems 2-spears with F100 emblems & hood crest DRIVER CONDITION
By rgs4x
One year only 1958 f100 hood emblem set with 2 spears and hood crest As you probably know the F100 part of the spear is almost always missing which makes this a rare find. Now for the disclosure....
Aaarrrggg!!!
By toddalin
Many here will remember that last year I sold my '64 Resto-mod to a gent in Memphis for $67,500. He had it transported from California. Image: He had the car for about 7 months and passed...
Audio Issues after installing Roadtop AA/AC module
By yfCN4o9XvF51
I just installed a roadtop aa/ac module on a 2018 GS350 with the Mark Levinson system. Now I have lower volume when playing media and a slight feedback whine that changes pitch with speed. However...
FS (For Sale) MOMO Quick Release Setup for C6 with Leather Steering Wheel
By wjnjr
14" leather steering wheel - real leather, not PU, PVC, vinyl, ABS - with gray stitching and TDC stripe. Approx 65mm dish. Comes with a MOMO v2.0 Quick Release, #177h hub adapter for C6, installation...
Vacuum lines diagram
By Luca Paindelli
I have a stupid vacuum leak somewhere triggering the cooling system failure in the dash... It's already hard as it is to track them so I was wondering if by any chance someone has a diagram of...
Clunk from underneath question
By SRBCitrusCobra17
This is not a new issue, but I have been curious about the source of the noise. I hear a clunk from underneath the car when I back it out of the garage, sometimes hear it when I turn a corner, and when I switch from forward to reverse. It is hard to tell whether it is from the front or the rear. This has existed for years, before and after engine removal where the K was dropped. My thought was in the suspension areas. I have looked at IRS mounts, front suspension etc. Nothing obvious... Read more
2000 KM round trip
By Clackavosticus
I am just about to embark on an approx 2000 KM round trip from Queanbeyan NSW to Tanunda SA return after having my coils and plugs changed to NGK branded coils and plugs. Wish me luck for a fault...
FS (For Sale) MOMO Quick Release Setup for C6 with Leather Steering Wheel
By wjnjr
14" leather steering wheel - real leather, not PU, PVC, vinyl, ABS - with gray stitching and TDC stripe. Approx 65mm dish. Comes with a MOMO v2.0 Quick Release, #177h hub adapter for C6, installation...
Washer pump mounting hardware
By commok
So my new to me 1987 Targa has a new pump in place between the battery and the condenser blower, but it is not attached to the body, just free ranging it. What size bolts are used to mount it to the...
WTB (Want To Buy) Fin Top FI plenum
By alsfarms
I am in need of a fin top plenum to incorporate with my current FI build. I will have a nice smooth top plenum with a tag calling for a 1962 hi HP application to trade. I will also have a 1962 FI...
WTB (Want To Buy) 1953 1954 1955 Corvette Windshield Post
By sundevil25
Looking for the pair. Please pm thanks
2027 Turbo S VIN# question
By RacerMike50
I'm a new member and I've only owned Porches since 2024. My 1st was a 2025 GT3 RS and now I have a 2027 Turbo S coupe being built. I was my Dealer's 1st 2027 Turbo S allocation and it reached...
FS (For Sale) C8 wide body, & C6 glass roof for sale
By EvanA
Hello all, I recently had my E-ray repurchased by GM through the lemon law. i Have a few items I purchased for it that I never got the chance to install and I’m now getting rid of as a result. ...
Vapor lock
By Dano76
My 79 F150, 351M, 4sp, everything stock, vapor locked on Sunday in about 70 degree weather on a sunny day. Its the first time its ever happened in the 4 years I've owned it. Luckily i had a friend...
New member intro from Louisiana
By LandesEnd
Hello --- New member here, but not new to Porsche. Ive previously had a 2006 C4S which was traded in back in about 2022. Couldn't stay away and now have a new 2026 911 S Coupe - Ice Grey...
Original 1960s-70s Plymouth Rent-a-Car Lighted Sign
By Floyd
Very rare and original lighted Plymouth double sided sign in working condition. The brass-plated sign box has light corrosion. Both sign faces are in very good condition with excellent color and only minor flaws (no cracks). Sign faces can be rotated based on preference for display (table-top or wall mount). Sign faces measure 10.5” X 10.5” and it stands 12” tall. $650 plus shipping from MD. Delivery to MCACN is also an option. Thanks for the ad! ... Read more
Forums & communities
110 listed, 26 connected and bringing in items.
Suggest a source
Know a publication, forum or channel we should list? Suggestions go to a review queue; nothing is connected until rights and identity are checked.